I had to drill down through the comments til I found the solution for me - I had to remove the capsule bucket and then press the 3 buttons! Thanks Lynne Moten "Thanks for this. Removing the front holder where capsules go is essential before you hold the buttons down. Just holding buttons down did not work for me"
I had this exact flashing light problem but nothing below fixed the issue. So I opened up the unit by removing the three screws in the base and sliding off the casing. And there hanging free was a wire. It was simple to see where it should have been connected to so I slid the wire into place and the flashing lights stopped and coffee is running perfectly :-)
Thanks for this. Removing the front holder where capsules go is essential before you hold the buttons down. Just holding buttons down did not work for me.
It works. Unplug it from the wall. Wait 10 seconds. Take the 2 front containers out before plug it again, press the 3 buttons at the same time. Plug the machine, keep pressing the buttons until you hear the beep.
Brilliant, it worked! Pressing all three button at the same time is the answer thanks. It actually started pouring water but I stopped that with a backwards slide on the slider then tried again and it bleeped and restored normal service.
Your machine is in descaling mode. Download user manual from Nespresso and work through descaling to finish the process. Don't forget you need to hold down all three button for several seconds and not just touch them. You must have water in the reservoir.
Just called support. You are in descaling mode. Remove the front part where the cups are stored and than press and hold all 3 buttons you hear a beep. You should be good after that.
Thanks IoP (Internet of People)!! My short-term apartment in Switzerland had one of these set in descaling mode. I thought I lost the ability to make coffee. This post solved my problem. Thanks all!
Just disconnect your machine for at least an hour I had to do that. Then when you plug it back in set your fingers if the water starts no worries slip the piece back where the pod goes. Then hold your fingers you will hear a beep. One light will stay on for me it was the middle one I proceeded with celebration and made a coffee.
you don't have to disconnect it for an hour. just when you cut the electricity you can plug it back in, turn it on and it's fine. but what is the problem causing it...?
I have finished descaling but cannot get out descaling mode. The lights keep flashing, even I press the three buttons at the same time, it just starts the descaling, and then after that the three lights flash on again. I have tried pressing the buttons when the capsule holder is out, but didn't work. What do I do?:(
@@pinkykaren1 same here. tried all the tips here. sometimes i can get the machine to make one more coffee, but then it does its blinking for several minutes and power cycling. i *never* get any beep - or reaction whatsoever - from pressing the 3 buttons.
The machine has started the "de-calcification" process. When the three lights are flashing just press the three buttons at the same time (with three fingers) and release when you hear a beep. After that your all good. This happens when you press the three buttons at the same time when cleaning for example. Hope it helps!
Suat Palanduz After doing a round of descaling (vinegar and water run through the machine a couple times), I went ahead and exited the descaling mode by opening the little slide and THEN holding down 3 fingers and I did get the beep! Secret is the open slide door, it seems. I had never descaled my machine! So I took this as a plea from my machine to finally give it some care. www.nerdwallet.com/blog/shopping/2014/how-to-clean-nespresso-machine/
Hello everyone just to let you know it worked for me too. After pressing the 3 buttons it sounded like it was going to descaling mode which is the same sound going off de scaling mode. So I assume it spontaneously went into descaling mode and I just took it off
thx....isn't the web wonderful.....had 3 lights flashing (had heard an alarm/alert noise from m/c shortly before) ...and as per posts here, held down all 3 buttons while load slide open and it cleared it.
Speak or something and tell us what this is supposed to mean. Is there a purpose to this video? Are the lights supposed to blink or is it broke? Why waste your time on this video and not explain anything about it????
Obviously it's not working as expected anymore and (s)he asks for help. Whats there not to understand? If you had this machine you would know that it's not supposed to blink, if you don't why are you even watching this video?
I had to drill down through the comments til I found the solution for me - I had to remove the capsule bucket and then press the 3 buttons! Thanks Lynne Moten
"Thanks for this. Removing the front holder where capsules go is essential before you hold the buttons down. Just holding buttons down did not work for me"
That works for me too !!!
It worked for me! Thanks
Thank you!
Great Dude , work for me too!!! Thanks a lot!!
Thank you!!
I had this exact flashing light problem but nothing below fixed the issue. So I opened up the unit by removing the three screws in the base and sliding off the casing. And there hanging free was a wire. It was simple to see where it should have been connected to so I slid the wire into place and the flashing lights stopped and coffee is running perfectly :-)
Owesome!!! Thank you......can now enjoy my coffee again. Note: press all three buttons at the same time with the LID OPEN
Thanks for this. Removing the front holder where capsules go is essential before you hold the buttons down. Just holding buttons down did not work for me.
You fixed mine - thanks! I wasnt removing the front bucket... was just about to call it off and send it back... thanks for posting!
Thanks. I'm enjoying a nice cup of coffee thanks to your suggestion.
Lynne Moten thanks so much. I was so upset though it’s broken:( you are the best
Thank you so so much 💕💕
Thanks! Worked beautifully. What a relief! I thought my machine was broken
Fantastic!!!! I also tried different resets etc. Removing the front did it. I will just join the choir praising this post. THANK YOU!
Thank you. My favourite machine and I think they have stopped making it so I am very pleased to have got it working again. 😀
Thanks.... press and hold the lights together sorted the problem. Now my machine works perfectly well as new.
It works. Unplug it from the wall. Wait 10 seconds. Take the 2 front containers out before plug it again, press the 3 buttons at the same time. Plug the machine, keep pressing the buttons until you hear the beep.
Brilliant, it worked! Pressing all three button at the same time is the answer thanks. It actually started pouring water but I stopped that with a backwards slide on the slider then tried again and it bleeped and restored normal service.
I try to pressing all three button at the same time just like video, but machine still keep flashing flashing flashing~~
Your machine is in descaling mode. Download user manual from Nespresso and work through descaling to finish the process. Don't forget you need to hold down all three button for several seconds and not just touch them. You must have water in the reservoir.
Tq tq it worked for me! Take the front capsule holder out n press the 3 buttons together. It made a toot sound n it was fixed! 😍
Thank you for the advice from RSA
Wow…it was blinking the 3 lights and after pressing the 3 buttons together it came back to life…thank you guys
It has worked. Thank you Tamara. You are a star.
Thank you so much! The flashing lights were driving me crazy. Much appreciated! :)
Hi Tamara. I have disconnected machine now.I will try it after an hour and let you know.Thank you for coming back to me.
ttesfcc Ndzzéwee1 reerrr34 gua m.
Just tried your technique & it worked flawless👍🏽
Brilliant - thanks . Thought it was a goner!
Thank you for your help I thought I was without my awesome coffee. Yippee
Just called support. You are in descaling mode. Remove the front part where the cups are stored and than press and hold all 3 buttons you hear a beep. You should be good after that.
Thank you so much. Driving me crazy! Finally working!
Thanks very much. i followed so many instructions and it never worked. Like Lynne mine only worked with the capsule door open. Back to coffee!
Thanks IoP (Internet of People)!! My short-term apartment in Switzerland had one of these set in descaling mode. I thought I lost the ability to make coffee. This post solved my problem. Thanks all!
Fantastiskt det fungerade :) thank you !
Oh wow awesome,thanks for this,i just found out what happend to my machine,and this the result 🧡🧡🧡
Thank you for this!! Fixed my issue :)
Thanks for this info! It sorted mine out too. Yay!
Thanks and it works well
Amazing! thanks so much.
Just disconnect your machine for at least an hour I had to do that. Then when you plug it back in set your fingers if the water starts no worries slip the piece back where the pod goes. Then hold your fingers you will hear a beep. One light will stay on for me it was the middle one I proceeded with celebration and made a coffee.
+Tamara Rodriguez thanx. i just fixed my machine. it worked
gulzar singh I'm glad it worked for you
+Tamara Rodriguez Thank you
Thanks switch off puch both buutons and put my finger on water outlet .
thank you!!
Woohoo, it worked! Thanks!
you don't have to disconnect it for an hour. just when you cut the electricity you can plug it back in, turn it on and it's fine. but what is the problem causing it...?
It worked for me thanks so much
I have finished descaling but cannot get out descaling mode. The lights keep flashing, even I press the three buttons at the same time, it just starts the descaling, and then after that the three lights flash on again. I have tried pressing the buttons when the capsule holder is out, but didn't work. What do I do?:(
Did you get a resolution for this? I'm having the same problem..:(
@@pinkykaren1 same here. tried all the tips here. sometimes i can get the machine to make one more coffee, but then it does its blinking for several minutes and power cycling. i *never* get any beep - or reaction whatsoever - from pressing the 3 buttons.
Nice
The machine has started the "de-calcification" process.
When
the three lights are flashing just press the three buttons at the same
time (with three fingers) and release when you hear a beep. After that
your all good.
This happens when you press the three buttons at the same time when cleaning for example.
Hope it helps!
I have removed the capsule holder and held all three buttons together. After 8 litres of water lights will not go off and no beep.
Suat Palanduz After doing a round of descaling (vinegar and water run through the machine a couple times), I went ahead and exited the descaling mode by opening the little slide and THEN holding down 3 fingers and I did get the beep! Secret is the open slide door, it seems. I had never descaled my machine! So I took this as a plea from my machine to finally give it some care. www.nerdwallet.com/blog/shopping/2014/how-to-clean-nespresso-machine/
Spot on. Thank you Joy.
Hello everyone just to let you know it worked for me too. After pressing the 3 buttons it sounded like it was going to descaling mode which is the same sound going off de scaling mode. So I assume it spontaneously went into descaling mode and I just took it off
thx....isn't the web wonderful.....had 3 lights flashing (had heard an alarm/alert noise from m/c shortly before) ...and as per posts here, held down all 3 buttons while load slide open and it cleared it.
I have been having the same problem! Does the U enter descaling process automatically?
It worked...!
Yap it worked :-))
Mines playing up how do push the buttons without it hurting ya fingers?
Anyone know the precise name of that red model of nespresso machine? I want it and can't find it anywhere............
Ted Thomas i have 2 of them that i dont use hahaha
I cannot work this machine. Just got it second hand
Well, did not work for me, just happened after cleaning the damn thing.
Ours did this after changing the spout part and it was because it had gone into Descaling mode
A
Is that supposed to be helpful!!
Speak or something and tell us what this is supposed to mean. Is there a purpose to this video? Are the lights supposed to blink or is it broke? Why waste your time on this video and not explain anything about it????
Obviously it's not working as expected anymore and (s)he asks for help. Whats there not to understand? If you had this machine you would know that it's not supposed to blink, if you don't why are you even watching this video?
thank you!