How to install an EXTRA Trim/Tilt Switch on your BOAT!

In today's video, I will show you how to add an extra Trim/Tilt switch to your boat. This can come in very handy when your button on the control box breaks or if you want to add another switch on your boat! It is a fairly easy process with no crazy special tools used. If you enjoyed today's video consider subscribing and liking the video so you can see more!
.
.
.
Tools Used:
Lighter or heat source.
Momentary ON/OFF/ON Switch: www.amazon.com...
Ratcheting Wire Crimper/ Wire stripper:
www.amazon.com...
Wire Stripper:
www.amazon.com...
Solder Seal Connectors:
www.amazon.com...
Heatshrink Butt Connectors:
www.amazon.com...

[@FishOn1]

Good info. Would have liked to have seen which wire went to which pole on the switch.

[@moedollaz2364]

Doing this method, you don't need relays or a circuit breaker? It's alot easier. Is there any cons of doing it this method?

[@austin.rivera]

I didn’t use any additional relays since the trim system already has them. This method just taps in to the factory wiring like an extension almost. Come is just more wiring to worry about but i think it’s more simple then breaking apart the control box and risk losing components or actually breaking stuff in there

[@raulcardenas8850]

What if the blue or green are not there, how do we run from engine/tilt?

[@austin.rivera]

Look for the relays that are related to that system you should see one wire coming from each going into the control box harness, if not try to trace the wire up in to the motor then out starting from the trim pump.

[@JerryEHamby]

You can change that controller switch for $15 dollars today