Shotgun Shell Light V3

This is my 3rd version of the shotgun shell lighter. The other 2 can be found in links below.
After reading a few improvement suggestions on the vid for version 2, I decided to add these into version 3. The main ones are that the cap that covers the wick is now connected to the lighter so you don't have to un-screw it (or potentially lose it!) The 2nd one is, I have removed the filler section on the bottom of the lighter which now allows the lighter to stand up! Filling the lighter is even easier now as you just remove the bottom shotgun shell cap.
I've made a step by step guide on Instructables which can be found in the link below.
www.instructab...
Version 1
• Make a Lighter From a ...
Version 2
• Shotgun Shell Lighter V2
Version 3 (short)
• Shotgun Shell Lighter
Jellyfish in Space by Kevin MacLeod is licensed under a Creative Commons Attribution 4.0 license. creativecommon...
Source: incompetech.com...
Artist: incompetech.com/

[@cri8tor]

This is a whole new level of recycling.
Keep the signal strong.

[@gabrieleciacci8602]

Dove posso acquistare i pezzi per farlo anche io a casa?

[@martinurinovsky7594]

What did you use to solder?

[@lonesoulsurfer]

I used a small blow torch.

[@martinurinovsky7594]

@@lonesoulsurfer thanks! And what kind of metal?

[@lonesoulsurfer]

I use solder with a little bit of silver in it. It forms a better and longer bond. You could also just use normal solder as well