Benchy in

After hours of searching for parameters that work well with each other, I finally got a setting which can do a 2min 20sec Benchy very stable.
This is now a good base to dial in the extruder to this enourmus speed and accelerations values, to get a bit better quality.
Printer Features:
THE100 with my 4WD mod (CoreXY)
Motors LDO 2504AC ... LDO's indestructible workhorse
Stepper Driver TMC5160
Powersupply Meanwell 24V/300W
Meanwell 48V/300W
Hotend Self developed on a Phaetus Rapido Base (about 113mm³/s flowrate)
Filament PLA @ 250°C
Partcooling CPAP WS7040
Extruder Voron M4 powered ba a 48mm stepper
Slicer ORCA 2.1.1
Print parameters:
First layers speed 850mm/s
General layer speed 875mm/s
Accelerations up to 185.000mm/s²
... many thanks to the developer of the amazing THE100 / @matttheprintingnerd

[@MattThePrintingNerd]

It's really crazy to see how far you've come in the last months, good job!

[@Volgger2278]

Thank you so much 😊

[@3DStuart-kf4gg]

Hello Volgger, respect, I think Monika is starting to get worried...😬 How many million steps does your smart watch actually show after a speedboat? Afterwards you'll probably go to the Stamm-table and brag about it...😂

[@Volgger2278]

Hi Stuart .... it's an intersting thesis - I'd check my stepcounter right after the next heat 🙂