Hi Bro, after this process that you did with Autel, that TCU is ready to be mounted on the car and ready in the car, there is no need to do any other programming?
@@markdasparkauto1780 friend, another question for you, if the non-working board is 722.9 V2, and I install the donor 722.9 V3. Will V3 work with the old firmware V2?
BEAUTIFUL JOB AND THANK YOU WE HAVE LEARN LITTLE BIT VERY NICE HOPE FOR MORE REGARDING A MERCEDES CAR TECHNICIAN.
Thank you 👍
Thank you. Very elaborate and precise
@@josephkebbi1146 you are welcome anytime bro
Thanks so much for the idea you share with me. You are the best
Exellent😊😊
Great job boss
Hi Bro, after this process that you did with Autel, that TCU is ready to be mounted on the car and ready in the car, there is no need to do any other programming?
The only programming you might have to do is a gear selection learn
Hello, will this process work for the vgs3nag2 ???? I have tried the launch padvii and it doesnt support clone for the vgs3nag2 only works for vgsnag3
do you have to save the TCM data from the old trans module first to write into this one?
Yes I had that data backed up from the old original one that I had save.
What to do if the old one is completely dead 🤔🤔
To precisando de um arquivo desse bom,vc teria pra venda??
No I don't have any files.
Bro, between can-H end can-L connected a 120 ohm resistor?
Yes you can put the resistor between high and low but it's much easier with the adapter.
@@markdasparkauto1780 So your adapter already has a 120 ohm resistor?
@@markdasparkauto1780 Did you download the firmware and coding from the old TCU?
@@serobmanucharyan3554 yes I did I had the file saved before. so all I do is renew and write the file into it
@@markdasparkauto1780 friend, another question for you, if the non-working board is 722.9 V2, and I install the donor 722.9 V3. Will V3 work with the old firmware V2?
What about new vgs tcu?
I don't think it is supported yet.
@@markdasparkauto1780i mean not used tcu from 2007 cars?!)