bro macam nak tahu switch tu yg rosak bro?..saya punya pun fusion rosak juga..bila nak on takda respone led pun tak nyala dekat switch sama receiver? tu ke tanda switch rosak bro?
@@TRCRT betul. Tu switch rosak. Kalau tkde switch, sambung je wire merah ke merah. Bila masuk battery terus on. Nk off kne cabut battery. Tpi lebih baik masuk switch baru
@@TRCRTmasuk simple switch on off settle masalah. Kalau main air, kne pki switch waterproof. Kalau switch tk waterproof, nnti main air tk boleh off sbb dlm switch tu ada air, cara die cabut battery je. Switch ni utk mudah kan kita onoff je.
@@MillyAire it is Fusion to receiver, receiver to transmitter. You can't just skip fusion to transmitter. Yes, you can't program. Once you buy fusion, install n some testing..sure you straight program the setup you need right? So at least if the switch broke you still can use fusion. You don't hv to spend more on new esc/motor.
Once you have soldered the new power switch in, get a servo extension wire, cut of the male side, and solder the female side on, white is signal, yellow is power, black is negative. this will allow you still to run the program card
How do you calibrate radio to esc when bypassing programming switch?
No need to calibrate. It will work like past setup and programming.
mana nak dapat switch fusion baru bro? tahu tak mana nak beli?
Tk ada jual la...try tanya2 kot ada yg fusion rosak. So boleh ambil switch tu.
@@malaysiaepicrcfilm noted bro..
bro macam nak tahu switch tu yg rosak bro?..saya punya pun fusion rosak juga..bila nak on takda respone led pun tak nyala dekat switch sama receiver? tu ke tanda switch rosak bro?
@@TRCRT betul. Tu switch rosak. Kalau tkde switch, sambung je wire merah ke merah. Bila masuk battery terus on. Nk off kne cabut battery. Tpi lebih baik masuk switch baru
@@TRCRTmasuk simple switch on off settle masalah. Kalau main air, kne pki switch waterproof. Kalau switch tk waterproof, nnti main air tk boleh off sbb dlm switch tu ada air, cara die cabut battery je. Switch ni utk mudah kan kita onoff je.
How to bind?
@@MillyAire bind what?
@@malaysiaepicrcfilm the fusion to the transmitter when there is no button also how to program the motor with no button
@@MillyAire it is Fusion to receiver, receiver to transmitter. You can't just skip fusion to transmitter. Yes, you can't program. Once you buy fusion, install n some testing..sure you straight program the setup you need right? So at least if the switch broke you still can use fusion. You don't hv to spend more on new esc/motor.
@@malaysiaepicrcfilm you can ONLY use it if it is programmed before. If not programmed then you’d have to buy proper button but it’s not available
@@MillyAire yes. You're right.
Once you have soldered the new power switch in, get a servo extension wire, cut of the male side, and solder the female side on, white is signal, yellow is power, black is negative. this will allow you still to run the program card
it is really work?
It doesn't work with mine
No don’t listen to him it doesn’t work
Köszönöm, sikerült! :)
Welcome 🤗
Mantap..done subscribe.
Tq amin 😁✌🏻
When I touch the two red wires together why do they get stupid hot
Maybe something wrong inside the motor(esc).
@@malaysiaepicrcfilmcoz ur a mong
Coz your a nugget?