Throttle Calibration on the HW160 and V-Control

[@overspeedrc]

Hey Nick, Thanks for doing such a great job on this video. It worked perfectly to use the HW 160 with the new EVO & Vtouch EVO. Appreciate it. - Safe Travels

[@daviderocchi3549]

hi Nick thanks for your video. I did as you say now I get this message "See esc manual! learn esc with collective stick" do you know what I have to do to solve the problem? thanks for your attention!

[@XFC8800]

thank you very much for this Video

[@bobbarker1667]

If your using a beast x put throttle to low plug battery in after half a second move throttle 2 100 percent wait for 2 beeps back to low throttle

[@MrLeeRossi]

I`m having trouble setting up my throttle on my v-bar touch radio. My esc is a castle 90.I went to the Vstabi site and downloaded the set up for this castle esc but it did not work. I have no control of the throttle stick .When I go to run it spools to full throttle can you help me out.

[@ThomasColeman]

nick can you show us how to setup the gov on vcontrol and hobbywing?

[@nickneo2007]

Do you need a throttle curve at 0 to 100 on the vcontrol first when doing the esc end points?

[@jctgf]

Why should I use the gov store mode? Isn't it a hassle having to wait the heli spool up for 15 seconds every flight before take off? Can't I simply use the gov elf mode?

[@nickneo2007]

The 15 sec 50 percent throttle calibration is done once and done. You don't have to recalibrate every flight. Use GOV. Store as it is the best setting.

[@th3s41nt]

so do you prefer this over the VBar gov? and does this eliminate the tail kick on spool up?

[@Sm1nts2escape]

Does it output battery voltage and bec voltage and all through the vcontrol?

[@bugoXngAZ]

Nick, how about governor setting? I am about to set up hw 100 for my logo 550, theres not much video that explains very well like you do it... Thanks

[@bugoXngAZ]

I think i got it, the last part of the video says it all. Thanks.