Pretty straight forward process, but just to confirm. At the beginning you installed 2 power injection points to the actual controller. But in this install you are only using one power injection line? If you would need to use the second power injection line how would you go about doing that, lets say the house is 180 ft, or whatever ft is required to start using your 2nd PI line, would you still run that line threw the track, or would you cut across the entire house attic?
I don't show it in the video because I did it later, but I went around the other direction from the controller and did the same thing I did in the video injecting power up to 80ft from the controller with that second power injection line. The two runs met at the corner where I stopped in the video.
Where can I purchase the input power box and controller? I need to inject power to a tree with LeD lights. There flickering now. I just need to make sure that I’m getting 12v at each section
What are you using for a power supply to run the lights right now? Can you just run more power from that power supply to feed power to multiple locations.
May I know what type of cable you use for power injection
We just get custom ones made for us, they are a 16awg 2 wire with a dc barrel connector on the end.
@@showhomelighting5840 is it copper wire or just a normal wire.
Where did you get those pucks that have a connector between each puck?
So you’re putting 2 Y-splitters at the spot where the next 5 LEDs will connect? Maybe you can make a short, close-up detail video of that.
Yes, I think this video needs to be redone and more to the point. Something for me to work on. Thanks.
Pretty straight forward process, but just to confirm. At the beginning you installed 2 power injection points to the actual controller. But in this install you are only using one power injection line? If you would need to use the second power injection line how would you go about doing that, lets say the house is 180 ft, or whatever ft is required to start using your 2nd PI line, would you still run that line threw the track, or would you cut across the entire house attic?
I don't show it in the video because I did it later, but I went around the other direction from the controller and did the same thing I did in the video injecting power up to 80ft from the controller with that second power injection line. The two runs met at the corner where I stopped in the video.
Where can I purchase the input power box and controller? I need to inject power to a tree with LeD lights. There flickering now. I just need to make sure that I’m getting 12v at each section
What are you using for a power supply to run the lights right now? Can you just run more power from that power supply to feed power to multiple locations.
You should post links where to buy the items. You can make a few dollars and we can find what we're looking for.
At the website Showhome lighting
are you running one DC injection wire with multiple drops along the way. Parrell wiring
Yes we are running a separate DC only wire from the controller inside the track and Inject power at 40ft and 80ft in both directions.
so its one DC wireand then two drops from that single wire correct.@@showhomelighting5840
@@showhomelighting5840 are you using the same dc line to inject twice or 4 times
Super confusing
Sorry, I'll try to make it easier next time. Which part is hard to understand?