I don't think I will as I followed a guide on 3D printing a better mount to do this on my own, I just didn't do any of the 3D printing or other parts, also it was so long ago that I don't remember what that guide was
Problem is that the phone charger sled is not only too short, it is too small width wise too. My Samsung device couldn't fit in it no matter what I did
@@zperrettaI have a Samsung Note 8. It definitely does not fit. It is too wide to even fit into it. I'm going to have to buy a smaller phone if I want to make it work.
On tutorials the whole job should be filmed. I’ll be back if you decide to do everything on video
I don't think I will as I followed a guide on 3D printing a better mount to do this on my own, I just didn't do any of the 3D printing or other parts, also it was so long ago that I don't remember what that guide was
Problem is that the phone charger sled is not only too short, it is too small width wise too. My Samsung device couldn't fit in it no matter what I did
What do you have? I haven't had any issues fitting my Sony Xperia 1 iii or Samsung Galaxy Note 8
@@zperrettaI have a Samsung Note 8. It definitely does not fit. It is too wide to even fit into it. I'm going to have to buy a smaller phone if I want to make it work.