Just bought a 2013 Nissan juke and watching your video you sold me I’ll get one of those ram air intakes awesome illustration on how to install it. Thank you..👍🏆
Thank you and Good luck! Only issue I ran into with the trans cooler was getting the hoses just right on the beehive cause they kept leaking. Make sure you check on them to make sure everything stays buttoned up
No at the time of this video it wasn’t installed yet. Here’s the install of my DV vs the blow off ruclips.net/video/1PdKBMy9NCI/видео.htmlsi=vPotgXxGARlYkrN8
No I removed all the stock piping. The lower one is held on with a 10mm bolt. You gotta pull back the splash guard to get to it. Then pull it out through the bottom.
removing the plenum isn't a good idea, the plenum is an air store that stops air starvation when you pedal to the metal, so remove the filter but leave the filter box (the filter box is the plenum, that's why it is so big for an air store) this is common mistake removing plenums, @ 2:37 when he knocks the pipe and says "get rid of all this hard plastic" that's where you want your short air intake with the paper filter removed,
Just bought a 2013 Nissan juke and watching your video you sold me I’ll get one of those ram air intakes awesome illustration on how to install it. Thank you..👍🏆
Awesome video! This made it easy for my install. Thanks from Sweden!
Very nice! Thanks for posting. I'm using your transmission cooler video to install mine and change my fluid this weekend. (2013 Juke 16GT JDM)
Thank you and Good luck! Only issue I ran into with the trans cooler was getting the hoses just right on the beehive cause they kept leaking. Make sure you check on them to make sure everything stays buttoned up
Nice video! Do you have a Blow off valve installed or is that sound strictly from the SRI?
No at the time of this video it wasn’t installed yet.
Here’s the install of my DV vs the blow off ruclips.net/video/1PdKBMy9NCI/видео.htmlsi=vPotgXxGARlYkrN8
Hi! Loved the video. Do you know if this would fit a 2015 Nissan Pulsar 1.6?
It’s the same engine but I’m not sure if it would fit in the engine bay. Better searching for a specific pulsar one. 😊
Did you block the original plastic pipe that goes all the way down? And how did you manage to open it cause the space was sooo tight
No I removed all the stock piping. The lower one is held on with a 10mm bolt. You gotta pull back the splash guard to get to it. Then pull it out through the bottom.
@meberra i see thanks!
removing the plenum isn't a good idea, the plenum is an air store that stops air starvation when you pedal to the metal, so remove the filter but leave the filter box (the filter box is the plenum, that's why it is so big for an air store) this is common mistake removing plenums, @ 2:37 when he knocks the pipe and says "get rid of all this hard plastic" that's where you want your short air intake with the paper filter removed,