MMU3 Build for the MK4 - Part 2 (Chapter 4)

Instructions -
help.prusa3d.c...
Prusa Affiliate Link -
By purchasing with this link, it helps out my channel at no cost to you
www.prusa3d.com...
Ways to Support TADA3DPrinting -
My Etsy Store -
www.etsy.com/s...
Become a member of TADA3DPrinting & get access to perks:
/ @tada3dprinting
Support this channel by purchasing merchandise - tada3dprinting...
Visit my Amazon Storefront - amzn.to/3Pxu31X
Need to contact me directly?
[e-mail]

[@cpunut]

I think your video is good for a beginning and an experienced builder. I use an egg crate or ice cube tray for bolts and such, kind of a handy way of organizing things while building. Nice job catching that bearing pin that was rolling away 😉

[@logicalfundy]

I used a Gridfinity tray I had printed earlier.

[@tada3dprinting]

I really like pulling the screws and bolts for each step so I don't forget anything. Do you still do this? Thanks!

[@brycejeannotte7699]

You are much more comfortable putting it together than you were the first time. Things are going very smoothly.

[@tada3dprinting]

Thanks so much!

[@BennyTygohome]

Very cool. You're basically becoming a mechanic. You should be able to rebuild an engine carburator after this 👍🤓

[@tada3dprinting]

Haha. In a later chapter where I am disassembling the MK4 nextruder, there is a step where you clean the grease off the gears. It gave me a strange flashback to "Small Engines" class in junior high. I definitely was more comfortable this time and enjoyed watching my own video instead of reading directions. Thanks so much!

[@redskyreconn744]

Legit ASMR meets printer building. Love it

[@tada3dprinting]

Thanks so much!

[@PerMejdal]

Hit: It is better to mount the F.I.N.D.A. a little too high, than too low. I managed to mount mine in a fluctuating state. Which halted the printer. I dissembled a reassembled the extruder, before I fount out I just had to raise the F.I.N.D.A.

[@tada3dprinting]

Man that's frustrating! Thanks!

[@gevanvliet909]

I would swear this is the (exact) same video as the MMU3 for Mk3 video. The devil is in the details I guess.

[@logicalfundy]

The biggest difference is really modifications to the printer itself.

[@tada3dprinting]

Yes for chapter 4 and 5, I reused a lot of video because the builds were the exact same. But I did add in the instructions and pictures from Prusa. Chapter 6 is the main video that starts to change. Thanks!