Design and Simulation of 3 Phase Fully controlled rectifier in MATLAB | SIMULINK

[@nafeesahmad1970]

Good Job

[@BrijeshKumar_electrical]

Nice

[@jalajaav7068]

Hi sir
If i change the firing angle to 90 what will be the pulse width.
12:19

[@smithchu6673]

I appreciate your video. Good lecture

[@Elite_Engineer]

Thanks alot Sir

[@farzeelraza8551]

thank you so much, it was very helpful

[@Elite_Engineer]

Glad to hear that!

[@dibyendusen2917]

very fine tutorial

[@Elite_Engineer]

Thanks alot 🙏

[@iDerezzed]

Hello, great video, I have a question for you. From what source of information did you get the table of firing angles?

[@Elite_Engineer]

Hello sir, that table i have made to make things easier, from the concepts learnt from my institution.

[@shekhar9119]

how did you switched on scr 1 and 2 it should be 6 and 1 , first if you follow phase sequence as ABC it will be ab ,ac, bc,ba,ca,cb, and as per your scr configuration , if we start from phase ab then scr 1 and 6 must go on

[@Elite_Engineer]

Yes you can follow the same dear

[@shekhar9119]

@@Elite_Engineer what was your sequence tell me

[@batrisyiaazizan6873]

can i replace the thyristor with diode?

[@Elite_Engineer]

You can try with that, i have not tried but it will work

[@shafakarina5316]

Thankkss

[@_ra__h]

Thanks buddy.

[@aramyusuf5626]

Do you have any vedio for firing angle 135

[@Elite_Engineer]

You can make it on your own, i have explained how to proceed in easy way.

[@aramyusuf5626]

Thanks 💐

[@Elite_Engineer]

My pleasure 😇

[@AhmedHamdyElnaggar]

I appreciate your effort, can you send me this file ?

[@Elite_Engineer]

I don't have this file now but i have explained every minute step in detail.

[@badshahengineeringvlogs9718]

I draw the same circuit but didn't work

[@Elite_Engineer]

Try again it will work. May be you are doing some mistake

[@tareqanwar5595]

afatoto thik ache

[@2000swetha]

Not getting the plot

[@Elite_Engineer]

Mam it will come please try again, I have made continuous video without any cut. Also if waveform is not coming proper try changing the power gui settings