Helpful tip. Typically I try to minimize offsets in my conduit runs. Especially wide ones, since I have been running rigid I couldn’t imagine trying to spin on a 10’ offset 😂
well i definitely understand what you're saying. doesn't hurt to know in case you run into the situation in the future. I try to keep my conduits with out bending as much as i can, especially on the job im at now cause we have to pull solid wire through alll our conduits up to 10awg.
Spread x .41 for your advance. Or tangent of half the angle x the spread of center to center
Thanks I needed this I been running conduit all week…
I got lots of conduit bending videos. Check them out.
Helpful tip.
Typically I try to minimize offsets in my conduit runs. Especially wide ones, since I have been running rigid I couldn’t imagine trying to spin on a 10’ offset 😂
well i definitely understand what you're saying. doesn't hurt to know in case you run into the situation in the future. I try to keep my conduits with out bending as much as i can, especially on the job im at now cause we have to pull solid wire through alll our conduits up to 10awg.
@@TheArtOfConduitBending I feel your pain. I say we write the NEC committee and tell them to make it code, no solid wire in conduit haha.
@@JayT1T1 that's actually not a bad idea. LOL.
You’re the big guy brother
How can I get that discord link? ⚡️💡🔌
Right on brother