Acuity nLight Wall Pod, Power Pack, and DT Sensor Demonstration
HTML-код
- Опубликовано: 16 окт 2024
- In this video, we'll be talking about the Acuity nLight Lighting Controls. Very simplistic and customizable lighting control system that can meet energy code when implementing an nlight Occupancy sensor and power packs. Keep in mind each device can be programmed and customized for each space that's not shown in this video.
See lnkd.in/gM-SRjz for additional information.
nlight Controls:
NPODM DX - Low Voltage Switch @ 15VDC
NCM PDM 9 RJB- Occupancy/ Passive DT ceiling sensor
NPP16 D EFP - Occupancy Dimming Power Relay Pack 120/277V
Special thanks to KSA and Frank Woodin @ CED/Efengee for donating these products.
Bro you sound very knowledgeable, I found you looking at accubid estimating. That’s the last thing I need to be able to apply at PM positions I’ve ran electrical work for 10 years. I also want you to know how to do design build, but better then redlines do you have any experience? I’m going to watch all your videos bro you the man! From Corona, CA!
so if you have 12 of these lights installed you just have to plug the cat 5 cable in and out to all the lights and switch and motion sensor in any order in a nut shell correct?
All the lights are powered from the power pack. The NPP16 can handle 16A of lighting load
Joesph Freeway
Any recommendations for receptacles , been working on Leviton product
Thanks
Yea ..don’t used 😅
How does this work if you have a three way setup?
@tylerzichterman1463 One Cat5 cable to the (1) Npod switch and back to the (2) Npod switch. From the last npod switch, take the cat5e cable to the power pack e.g. a npp16 power pack.
How can you program the ceiling mount sensor for sunlight dimming
I did it once on an app where I plugged in the programming codes found on occupancy sensors. I do not remember what the app was called
DUDE!!!!
WHY YOU SMACKING YOUR LIPS LIKE THAT!!!!!!!!!!@@