2008 RZR shift problem fixed!!

This 2008 RZR was brought to me with a shifter that didn't feel right. It was grinding and hard to pull. I fixed it last year by the same method shown in this video but this year it sprung a leak and a bearing went out. Therefore I had to pull the trans again.
When putting it together I put an o ring in the wrong place. That's why it didn't shift into low or high. So this time pulling it apart I filmed it and wanted to show how to fix the shifting issue that is so common among these models of SXS.
If you pull the trans and the parts shown, just weld the plate onto the shaft so that it will no longer leave a place for the ball bearing to fall out. That way it is stronger and reliable, better than new.
I hope that this helps get you back on the trail or at least let you know what you getting into.

[@eyeorewolf]

Great video. That little thing with the spring and the ball and the holes is called a detent,

[@HTXRZRREVIVAL]

Following along brother! I was very new when I rebuilt my transmission and to be honest I’m not sure I did it right haha. Dealing with not getting high gear right now but I’m working on it!

[@youtee2010]

So was the problem with yours that it felt like there was no ball and detent or that it wouldn’t go into gear? If it won’t go into low or high, what is likely wrong?

[@vadimih2427]

Спасибо большое! Подскажи пожалуйста, всё дело было в этой пластинке???

[@StarknightMT_official]

Hello, Are you interested in testing our products? We would like to invite you to test the Phone Holder for your 2008 Polaris Ranger 500