The documentation is a bit of a patchwork mess, to be honest. Start with the Voron Trident Assembly Manual, then supplement with the details from this Github repo: github.com/FrankenVoron/Tridex Finally, I have been getting even more help from active Tridex users in the DoomCube Discord server's #tridex-dev channel.
@@Dead_Aim556 one cable runs from Toolhead0 to the white Molex Mini-Fit 2x2 port on the U2C, and one runs from Toolhead1 to the black Molex Micro-Fit 2x2 port on the same U2C. Need 120 Ohm resistor jumpers on two of those three devices, so I will likely leave the jumper off of the U2C, and add it to both EBB36s.
good progress!
Currently adding heatset inserts into all of the toolhead parts.
Are you using a Tridex guide for assembly and could you share it?
The documentation is a bit of a patchwork mess, to be honest.
Start with the Voron Trident Assembly Manual, then supplement with the details from this Github repo:
github.com/FrankenVoron/Tridex
Finally, I have been getting even more help from active Tridex users in the DoomCube Discord server's #tridex-dev channel.
Awesome! Don’t you need 2 U2Cs?
No, a single U2C can drive both toolhead boards, I'll be using two EBB36's
@@oldguymeltsplasticso where does the second canbus cable terminate too?
@@Dead_Aim556 one cable runs from Toolhead0 to the white Molex Mini-Fit 2x2 port on the U2C, and one runs from Toolhead1 to the black Molex Micro-Fit 2x2 port on the same U2C. Need 120 Ohm resistor jumpers on two of those three devices, so I will likely leave the jumper off of the U2C, and add it to both EBB36s.
voron modder people scare me.
🤣