At 0:39 the video says the first row is positive, middle pin negative. However this is incorrect. At 1:40 the plug has the red (positive) wire in the middle, black wire (negative) is on the right which is correct.
@HotRC-Shopy I have touched all the buttons and deconfigured both the receiver and the transmitter completely. Is there any option to reset both the emitter and receiver to factory default values?
Hello, it is like this, we set the digital steering gear mode on the receiver, the channel mainly depends on which channel you connect, the connected channel can directly use the digital steering gear
my receiver suddenly died. even though it had only been used a few times. it died during a new servo test. the led didn't turn on and the receiver was really hot. is it overheating or is there a problem with the esc or servo
1. Connect the power supply and receiver 2. Press the small button on the receiver (code matching button) 3. When you see the receiver light flashing, turn on the remote control 4. Code matching completed
At 0:39 the video says the first row is positive, middle pin negative. However this is incorrect. At 1:40 the plug has the red (positive) wire in the middle, black wire (negative) is on the right which is correct.
@HotRC-Shopy I have touched all the buttons and deconfigured both the receiver and the transmitter completely. Is there any option to reset both the emitter and receiver to factory default values?
Which remote control are you using?
i has a question when u turn on the digital servo mode what channels are only affected by it?
Hello, it is like this, we set the digital steering gear mode on the receiver, the channel mainly depends on which channel you connect, the connected channel can directly use the digital steering gear
What does green qnd blue light blinking at the same time mean
Are there any wrong signal connections?
Can you change the speed of the servos with this radio?
Do you want to adjust the speed fast or slow?
@@HotRC-Sophy yes, when servo is connected to channel 5 switch. When I flip switch, can I make it so the servo is slower for flaps?
@@magicmike1122 It cannot be adjusted, the remote control does not have this function
How i can turn off blu light.
Ok, i do alrealdy
Can i pair this with my HotRc CT8a?
The C-04A receiver cannot pair with the new CT-8A transmitter
Hello can u help me ..how can i bind the resiver CT -400A with the old trinmiter CT -400..???
I'm sorry, it may be a translation problem. I don't quite understand what you mean. Could you please elaborate on your question?
my receiver suddenly died. even though it had only been used a few times. it died during a new servo test. the led didn't turn on and the receiver was really hot. is it overheating or is there a problem with the esc or servo
How much V are you using to power the receiver?
@@HotRC-Sophy battery 2s.li-ion 7.4v 1600mah.esc 30a.out of the esc about 5.5 volts to the receiver
@@heryjangkung It may be that your ESC or servo power supply is too high, causing the receiver to burn out
what is the difference between ct600 (4+2), pwm and regular ct600? Please answer
(4+2) ch1--ch4 of the receiver are pwm signals, ch5 and ch6 are level signals. The 6-channel receivers are all PWM signals
@@HotRC-Sophy
so why on my ct600 receiver (4+2) ch5 and ch6 can't be used for LED or winch?
@@barbaraleonidas7352 Only use low current led lights
How does the receiver turn on?
1. Connect the power supply and receiver
2. Press the small button on the receiver (code matching button)
3. When you see the receiver light flashing, turn on the remote control
4. Code matching completed