Replacing the hydraulic wet kit pump on a semi-truck

The old pump was over heated and the original installers didnt apply thread locker to the bolts on the mounting flange so the entire pump had to be replaced.
Check out the pump tear down video • PTO hydraulic pump tea...

[@CMWally]

I realize this is 4 years after you did the work, but there needs to be a bracket supporting the rear of that pump. The reason the bolts came out of the flange is the pump bouncing on the flange stretched the mounting bolts, allowing the bolts to back out and fall out of the mounting flanges. You are lucky the aluminum mounting flange didn't strip out.

[@anthonywashington2492]

The flange usually cracks off out in west Texas oilfield

[@Ray69Smith]

Your not supposed to use teflon tape on the pipe threads !!

[@marcogutierrez8545]

Do you need to bleed it afterwards?

[@C.O.SBurpees]

I really need to know too I had issues installing it and low pressure the old pump bind up and I replaced it but no pressure. I tried to adjust the pressure relief valve and still nothing

[@luismdoz]

Do you need to add grease to the spline hole?

[@TheBaron97]

Thanks

[@joaquinhernandezolive6307]

what is the cost to install the pump?

[@adamb4093]

Tank pump and pto 3 to 5 grand to buy to have someone install 15 to 25 grand

[@psmith535]

Horse poo, we bought a new pump for $320, tank and hoses for another $685 and paid $375 to have it all installed. Works perfect.
25 grand??

[@dragonslayer2535]

@@psmith535 where you get those lines pump and tank