61FL Panhead Pushrods and Tappets #4 @SilverNutsGarage

Поделиться
HTML-код
  • Опубликовано: 23 ноя 2024

Комментарии • 4

  • @MoeLarrycurly1
    @MoeLarrycurly1 17 дней назад

    On the hydraulic unit where you put the torch tip cleaner where does that oil come from or where is it going or where does the hole go to in the cup. Thanks for your excellent video

    • @SilverNutsGarage-di5ls
      @SilverNutsGarage-di5ls  17 дней назад +1

      Great question!!!! Long story short. The oil comes from the engine oil pump up into the tappet blocks, through the oil passages and that's the oil that fills the hydrolic piece of the lifter that also oils the cup that the end of the pushrod seats into. On a side note........, Did you happen to catch my mistake?

    • @MoeLarrycurly1
      @MoeLarrycurly1 17 дней назад

      ​@@SilverNutsGarage-di5lsno I don't think so. I've got two shovel hands and probably the oiling systems about the same so this is helping a lot Thank you. I'll be nosing around mine maybe this winter just taking it apart and see. My rear shoes grab pretty quick so I'm going to put some new brake shoes in the back of my 1970 I've done the front and it's a world of difference mechanical breaks aren't the best. The even worse when they're worn out. Mine squeak pretty good now but they stop

    • @SilverNutsGarage-di5ls
      @SilverNutsGarage-di5ls  17 дней назад +1

      @@MoeLarrycurly1 Good luck and ride safe. Thanks for the comments, it's appreciated,!!