Rx8 why wont it start EGI comp 1 fuse blown ! But why ?

if your EGI Comp fuse 1 is blowing, A look at all the Things that Will Blow the Fuse ssv valve ,oil metering pump, o2 sensors or some one being carless doing a clutch

[@davidacevedo6477]

nice you sure do know your stuff when it come to rotarys very helpful ..

[@TheRogueOnes]

Thank you

[@user-bk7tx7fu6w]

Yes one of the few creators who doesn’t immediately blame compression I love your videos man!

[@john-nu5py]

its amazing what other shops do and charge people to mess up there cars worse than what they went in

[@TheRogueOnes]

Its crazy right

[@johnkassel318]

Getting code U0100 on an automatic 08 that we just rebuilt the engine for, sparks are working but dry, compression is fine, mother lines are good, all plugs are correct and in place. Stumped as to why it won’t turn over on start up.

[@TheRogueOnes]

like its not turning the starter at all or just not starting... if the starter is not cranking with that code you have a bad engine main ground that bolts on the center iron by the oil pan

[@azgard8914]

Hello I put a new battery in 2008 rx8 and now steering to the right is stiffer……I know I shorted the positive when I changed battery because it sparked do you think iv blown a fuse……what could be cause of stiff steering to right….iv cleaned both grey ports below air box

[@TheRogueOnes]

Try a reset on the steering

[@DIYtips-uo6ej]

I have a rx8 but the fuel injection are not getting light from the brainbox what can I do

[@TheRogueOnes]

Getting. Light from the brain box ? The engine control. Module uses ground signal to fire the injectors so that is. Good If you have no power to the injectors i would start by checking the fuses

[@MunivishaalMudaliar]

I have rx8 and all check light comes on and mile meter is also not work

[@TheRogueOnes]

plug a scanner in.... any codes ?? not sure what your asking mile meter ? do you mean odometer ? if that don't work then u will need anew cluster like all check light abs ? engine light ? low coolant light there's a few

[@askmewhatyouneedtoknow5342]

I have my 2007 Mazda rx8 When is cold Cranks For like a second to end it turns on but if I run it for like 30 minutes and it gets hot it doesn’t turn on it’s just cranks but it don’t turn on and once I reach 50 or 60 mph It feels like it doesn’t run to full potential and after I get out the freeway start running regular it feels like if it Shutting off sometimes feels like it’s going to shut off and some occasions It did and the hard part is that I have no service engine I have no sensor service or anything so is there a way you can help me on that

[@TheRogueOnes]

The. Engine. Is in need of a rebuild thats the. Biggest sign. Of the engine. On its way out

[@askmewhatyouneedtoknow5342]

the not good and how much it going to be for a rebuild engine

[@TheRogueOnes]

That would all come down to the condition of your engine in reality any were between 3700 - 7k depending on what is needed

[@askmewhatyouneedtoknow5342]

But the thing is when I turn the engine on it table if I don’t if cross the 40 mph is table only happens when I go up from 40 up and. I haven’t changed anything on the car since everything is original so I’m the one Who changing a few things so doesn’t have to do with the SSV volts or something to do whit ssv solenoid ssv Like the air flow

[@MunivishaalMudaliar]

Bro

[@TheRogueOnes]

??? bro ???