2010 CHRYSLER TOWN & COUNTRY - HOW TO REPLACE SPARK PLUGS & SPARK PLUG WIRES - COMPLETE DIY
HTML-код
- Опубликовано: 1 сен 2019
- Spark plugs used in the video: amzn.to/2ZLWhsO
Spark plug wires similar to the ones used in the video: amzn.to/2MSi9Rl
Anti-Seize: amzn.to/2ZE4jbk
Long Handle 3/8" drive ratchet: amzn.to/34jsn2A
Torque Wrench: amzn.to/34t0Goa
5/8" Spark Plug Socket: amzn.to/2NGX6AO
Just a quick video showing how I replaced the spark plugs and spark plug wires on a 2010 Chrysler Minivan with the 3.8L V6 engine. This would be similar for Dodge Grand Caravan as well.
Pretty easy job, just make sure you use enough anti-seize or the spark plugs will be difficult to remove the next time you change them. These were all stuck pretty good, but luckily they all came loose with the long handle ratchet.
Torque for the plugs is 13 ft lbs. Or the Spark plug manufacturer recommends 1/16th turn after the plug seats into the cylinder head. Since I used a little anti-seize, the torque wrench still felt pretty accurate, and looked pretty close to 1/16th of a turn.
The spark plug gap I found online was .050
Thanks for watching!
Please Subscribe!
-Dan the Fix it Man
Song used in the video:
"Third Eyes" by Text Me Records / Bobby Renz
As an Amazon Associate I earn from qualifying purchases. 
Авто/Мото
There are more than several videos out there for changing spark plugs and wires on this engine and its 3.3L cousin. Of those I've seen, this one is the best, because it shows you going through the effort of getting those back spark plugs out and in. I don't replace spark plugs on a regular enough basis to remember the "tips of the trade". Gap the plugs? Use anti-seize and how much? Use dielectric grease and how much?
I have a 2009 T&C with the 3.3L engine which, interestingly, uses the same firing order as shown in this video. My T&C has 144,000 miles on it, and I'm certain the plugs and wires were never changed before today. I could not get the wires off the plugs without leaving the clamps from the wires stuck on the plugs. Thankfully, I'm replacing both the wires and the plugs, so no biggie. The clamps were easily removed using pliers. The ground electrodes were well "worn" and the gaps exceeded the 0.050" spec.
The advice on gapping and anti-seize are *very* dependent on the replacement spark plug. I'm using Bosch Double Iridium plugs, and the packaging explicitly states "Do not gap" and "Do not use anti-seize". I've heard before that attempting to gap iridium plugs may actually damage them. The Bosch plugs were pre-gapped to 0.050" and that matches the spec for my van.
Excellent video. Inspiring how easy you made
this! Thank you!!!
Thanks for the video, it’s very helpful. I’m going to do it today. Thanks a lot
Awesome video. Thanks for the help. Now I know how to change spark plugs. lol Saves me money.
Excellent video. Thanks!
Well Done!!
Doing this on my 10 town n country thank u fam
Great camera angle and light. Wish you have a chance to do spark plugs for 2007-2010 Sienna minivan 3.5 V6.
All videos available miss a point or more especially the plenum back screw (they do the hard top one instead of the lower one). Most of them are non pros.
Great video. Thanks for this. I am going to do this on my 10 T&C this Sunday. She's got 222k ok her and I don't think the plugs have been changed ever, atleast not in the last 130k for sure.
What was the length on the extension you used?
Great simple video. Thank you. If you get this before I try later today, why did you replace them? Mine is idling rough. Thanks!
Just general maintenance, it was running ok. But the owner said it ran a little better after changing them.
Best of luck to you!
-Dan the Fix it Man
@@DantheFixitMan thank you for the very kind and quick reply!
.044 is the proper gap.
What happens if you don't gap the spark plugs?
The prophets of the car gods have foretold of this event for decades. If one does not gap their plugs, then Russia will invade Ukraine and start WW3. What have you done?!?
Seriously though, it will probably run rough.
Engine manufacturers determine the exact gap that gives the best performance. If the gap is too big or too small, performance and gas mileage will suffer, and your plugs may wear prematurely. Some plugs come "pre-gapped". I've heard that gapping iridium plugs could damage them; these will come pre-gapped.
⁷qu