Back inner part of the orange box is not good - it does not provide solid support for the cells for their whole surface. The cells are only pushed on 4 square beams around the perimeter and there is no solid support in the center for the cells and that is not good. It would be necessary to make the inner back part with full filling with solid support the whole surface for the cells.
Thank you for your comments and suggestions on the UBPPOWER DIY Battery box kit. There are two support points in the middle. Moreover, this is a metal casing, not a plastic casing. You can be completely assured!
@@Ubppowerlifepo4battery Cycling cells work by inflating and compressing even when cells are compressed, for this it is better to have full support for the whole surface of the cells at the back. For boxes where this is missing, people are there adding aluminum plates to have the same equal support for the whole surface of the rear cells as well. But it would be better to have it factory modified like this. Maybe when you sell out of stock already made boxes, the next ones made can already be with this improvement.
The second last and the third first wire were connected to the eighth. If the wire is only 16 s, then what to do?
I want one.
@@whyme2500 You can contact me via the following email address and I will reply to you as soon as possible. Thank you! Johnlan@ubppower.com.
where can I buy it?😊
@@Delany-e3s Log in to our official website: www.ubppower.com, and send me an email at Johnlan@ubppower.com.
where can I buy it?
You can contact me via the following email address and I will reply to you as soon as possible. Thank you! Johnlan@ubppower.com.
Back inner part of the orange box is not good - it does not provide solid support for the cells for their whole surface.
The cells are only pushed on 4 square beams around the perimeter and there is no solid support in the center for the cells and that is not good. It would be necessary to make the inner back part with full filling with solid support the whole surface for the cells.
Thank you for your comments and suggestions on the UBPPOWER DIY Battery box kit. There are two support points in the middle. Moreover, this is a metal casing, not a plastic casing. You can be completely assured!
@@Ubppowerlifepo4battery Cycling cells work by inflating and compressing even when cells are compressed, for this it is better to have full support for the whole surface of the cells at the back. For boxes where this is missing, people are there adding aluminum plates to have the same equal support for the whole surface of the rear cells as well. But it would be better to have it factory modified like this. Maybe when you sell out of stock already made boxes, the next ones made can already be with this improvement.
@ Yes