I was going to say as long as it sticks it don't matter what it looks like but then you show how good you can lay down a weld really good. Yeh, I'm not a fan of stick welding though it can be useful. No need for the pump though and it will wear out unfortunately. My drip feed is set up with a auto shut off fill so I get a constant drip rate without worrying about the electronics part or mechanical pump. Depends on how long and often you use it though as to how long the pump will last. Great setup though all round.
Your drip shutoff sounds interesting, I went with the pump setup because I wanted a failure in the setup to result in a shutdown in the burner, I may wire in some thermostat based lockout relays to prevent the pump running if the burner goes out, at a pair for 12 buck I consider them a consumable. Also discovered that the oil drip tube is actually drawing air into the burn chamber, causing a colder burn. When I plugged it with my finger heat output increased immediately. Will post another video when it gets colder and I can run it.
![Summer Walker - Heart Of A Woman [Official Lyric Video]](http://i.ytimg.com/vi/SFddctbZzw8/mqdefault.jpg)
You make this look so easy.
I was going to say as long as it sticks it don't matter what it looks like but then you show how good you can lay down a weld really good. Yeh, I'm not a fan of stick welding though it can be useful. No need for the pump though and it will wear out unfortunately. My drip feed is set up with a auto shut off fill so I get a constant drip rate without worrying about the electronics part or mechanical pump. Depends on how long and often you use it though as to how long the pump will last. Great setup though all round.
Your drip shutoff sounds interesting, I went with the pump setup because I wanted a failure in the setup to result in a shutdown in the burner, I may wire in some thermostat based lockout relays to prevent the pump running if the burner goes out, at a pair for 12 buck I consider them a consumable. Also discovered that the oil drip tube is actually drawing air into the burn chamber, causing a colder burn. When I plugged it with my finger heat output increased immediately. Will post another video when it gets colder and I can run it.