I have a question which make me confused ! I want to calculate heating and cooling loads in a project ( actually it is artificial project in order to learn Carrier software) - My system is AHU - in the section of Central cooling - supply temperature is set on 58 F as default. First question is that " is there any optimum ( or range) temperature for this section ? On the other side, I want to simulate this system ( AHU) in PSYCHROMETRIC ANALYZER software - after the cooling coil, there is a place at which I have to enter a figure. Should these figure be the same ? ( I means SUPPLY temperature in Carrie and temperature after cooling coil in Psychrometric analyzer software ) . i would be grateful if you explain me about these two figures and their optimum value.
Dear, 58 is the grill supply temperature. This depends on the indoor air design slections (temperature and humidity). The grill supply temperature should be less than the dew point at the specified design data. For example 58 deg F is the maximum suuply temp for an indoor air selections at 24 deg c and 55 relative humidity. You can check the psychometric chart for your air desig inputs.
Sir you are keeping everything same atleast you should give us concept like what and when we have to change it, for example Min CWT 60F this is from where? Also minimum 20% load for chiller from where, are these values are std or what. Thanks
Nice explanation.👍
Mashallah Engineer it was a nice session but I would suggest you, give the reasoning while you select some option or value in a particular parameter.
Nice video...
Can you please do vedio for air cooled chiller units
I have a question which make me confused !
I want to calculate heating and cooling loads in a project ( actually it is artificial project in order to learn Carrier software) - My system is AHU - in the section of Central cooling - supply temperature is set on 58 F as default. First question is that " is there any optimum ( or range) temperature for this section ?
On the other side, I want to simulate this system ( AHU) in PSYCHROMETRIC ANALYZER software - after the cooling coil, there is a place at which I have to enter a figure. Should these figure be the same ? ( I means SUPPLY temperature in Carrie and temperature after cooling coil in Psychrometric analyzer software ) .
i would be grateful if you explain me about these two figures and their optimum value.
Dear, 58 is the grill supply temperature. This depends on the indoor air design slections (temperature and humidity). The grill supply temperature should be less than the dew point at the specified design data. For example 58 deg F is the maximum suuply temp for an indoor air selections at 24 deg c and 55 relative humidity. You can check the psychometric chart for your air desig inputs.
sir, there is no tutorial part -3??
was there a mistake in previously uploaded tutorial 2???
please upload video on duct sizing, air flow, cfm etc.
i could see that this is for the same project but some parameters have been chosen differently here
Sir you are keeping everything same atleast you should give us concept like what and when we have to change it, for example Min CWT 60F this is from where? Also minimum 20% load for chiller from where, are these values are std or what. Thanks
Hi please guide to hap software available free download or trial version
Send your mail id. i ll forward you In sha allah
can u send to me also abaxxacaba at gmail dot com
@@hafeezrahman7225 aloshybinu@gmail.com
yes sorry, i removed and corrected.
Kindly send me your email id. thanks
Quiess
Reply me