⚡️DC Rectified Hoverboard⚡️
HTML-код
- Опубликовано: 5 сен 2024
- I may in a later video show an in depth of how to regulate voltage from a hoverboard generator!
Running a Tesla Coil off Hoverboard motors
• Green Energy Powered T...
This explains Buck Converters
• Buck Converter Explain...
Bench testing Hoverboard motor
• ⚡️Bench Testing Hoverb...
Music: Discover
Musician: @iksonmusic
Awesome clear description on how to use these motors to generate electricity!!!
Thank you!!
To use these as a generator. Hook the wires to diodes. Use 6 of them rated for at least 3A. Wire 3 diodes with the polarity going in and 3 diodes with the polarity going out. It is a 3 phase rectifier. Keep the frame and trim as needed for your project. With moderate spinning it makes about 24V at 2A. The open circuit voltage can get as high as 60V so you definitely need a voltage regulator or converter with these. They make awsome peddle power generators. Recommend using a capacitor and wide compliance DC to DC converter module. Also a voltage regulator for a riding lawnmower works good for charging 12V batteries with a windmill.❤
What a load of old cobblers. Absolute tommyrot. Just another SCAM, SCAM, SCAM.
@@moking8095 I'm not sure what you talking about but for a generator these motors work not trying to run the motor off of dc just generating power
@@moking8095 ruclips.net/video/y-FkTr6bxuo/видео.htmlsi=FH3_mwqz2MUkPXjI
very good man
@@WisdomShortvids thank you👍
This type of motors an be converted in motor-generator, leave 1 phase in place as it is and disconnect the other 2. Disconnected phase will go for output wired in parallel, dump in a cap bank and for there use half bridge (one wire system) with one to feed back the motor (phase left in place) while the rest is to power whatever you need.
This type of motors are very powerful and when 3 phase are used makes 3 motors in one. Just disconnect all other circuits and make your one, eventually if batteries are in good condition use them instead of cap bank. Magnets might need to be repositioned or replaced if output do not sustain the motor and same extra … ideally 36 coils with 12 magnets in such arrangement that 1 powered phase will have at least 1 induced phase on two coils diametrical opposed.
To see easy how they go make two cardboard circles, 1 for magnets and 1 for coils, make different arrangements until they reach desired position, in such way to make a pump mechanism on diameter, one shrinking and the opposite growing, than next set, than next, while 1-2 magnets reach the powered coils from phase 1.
So, no need to go for wind power.
Thank you for the information and video! I appreciate the effort you put into your channel !! Do you have a setup using the hoverboard generator to charge a 12v/100AH battery? It would be awesome to have a setup using the hoverboard to charge batteries to have for camping or emergency situations…. Thanx!
With a buck converter you can!! Like a DC to DC up to 60vdc input and output 0 to 60 at 10amps so just set it to 14vdc or whatever you need and you can limit the max amps you want to charge at to a maximum of 10amps
@@ArcAngelTeslaCoil Thank you for the reply! Your knowledge far outweighs mine on this topic. Would this be a video you’d be willing to take on? I wouldn’t know to set this up… Is a charge controller needed ? Something that would handle 3 phase from a wind turbine or one used for solar panels? Would a Lithium battery charger be better driven from the hoverboard?
@@jlh2119 let me see what I can do just give me a little time👍👍
Alien said you got it, fantastic mate. From Australia.
Thank you👍
Thanks for this! Green energy tesla coiling 🙏
Thank you!!
could you show how to make to 220v ?
220vdc? Or A/C
Use with battery and inverter?
didn’t show the output or how to use in practice!
@@neilbrown3847 ruclips.net/video/LU5yedEhZkU/видео.htmlsi=sTix62Yd7BAdGf4e does this help?