I subscribed and tried to click onto the LIKE button, but there isn't one. There is only the DISLIKE button which has 492 clicks on it, and that can't be right. What gives with RUclips? This is an excellent video.
Thank you very informative! similar with your case, my 2001 Mazda tribute (Escape's twin) is throwing the same code! hopefully it goes away with a simple solenoid replace and hopefully wiring is ok.
Is the top round circle peice suppose to spin right and left? I noticed on my wife's car it'll spin easliy when I was doing some trouble shooting on terminal/contacts.
Question adam I have an1409 EGR Vaccum Regulator Solenoid Circ I replaced it ran it for about 40 miles engine light came back on. What else can it be? Should I clear the code again and run it straight for 70 miles or plus. My other question after clearing the code can I do multiple ride cycles for code to reset or needs to be done in one driving cycle.
Hey Adam I have a 04 Ford escape I noticed recently that my engine sounds a little louder than normal and shakes a little while driving.i am very loyal to my oil change every 90 days because I do alot of driving had a little work done on her recently.i had a coolant leak and a small oil leak.can that be the cause of my engine running louder
I got a 2003 Ford Escape v6 when I'm at a stoplight when it's in drive and I turn my AC on it drops idle and wants to die but if I turn my AC off it goes back to normal idle
hmm, I would start by checking the idle air control vale to make sure that is clean and working properly. it could also be something not communicating to tell the computer the ac is on and to compensate.
Was your new part an OEM/Ford/Motorcraft part? When sensors are involved, it is usually better to pay extra for a proven part. I've had to learn the hard way.
another question Adam... what would happen to the car if left as is? just out of curiosity.. as mentioned on my previous comment, I have the same code (P1409) ... Thank you so much.
It's part of your emissions if it's stuck closed you just have higher pollutants if it's stuck open your car will run like crap. Either way your check engine light will be on.
Mine is on... I'm noticing power seem less than normal (tad sluggish) and idle is a bit rough (no misfiring). Almost forgot my MPG is 19.1 for last tank (when light came on) and I was getting closer to 20-21 before.
I have an 06 Ford Escape. Im tired of throwing money into it can someone please help. This is what it is doing The car start and drive great for 4 miles then it will stop pulling. U can turn the car off let it cool down and restart and it does the same thing all over. Please help!
Hey adam i replaced the solenoid and it actually made the rough idle worse, as tho the car wanted to die. Do you suspect it of being the wire, as well?
JJ Jetplane yes i would suspect the wire, it will look fine but the wire breaks right at the connector. I picked up a new connector at the local parts store.
Check the wiring, it could be bad at the connector just like this one was. Also you may need to reset the check engine light or wait for a drive cycle for it to go out.
@@adamanderson8631 question I also replaced part engine light it’s on after driving like 45 miles engine light came back on. How many miles would a drive cycle be. Do I have to reset the engine light and begin a new drive cycle for engine light to reset.
Didn't even test it before removal...... Such a bummer, I'm very well acquainted with lefty loosey, thanks for the vid 😅
Thank you very much.fc from Thailand
I subscribed and tried to click onto the LIKE button, but there isn't one. There is only the DISLIKE button which has 492 clicks on it, and that can't be right. What gives with RUclips? This is an excellent video.
Thank you very informative! similar with your case, my 2001 Mazda tribute (Escape's twin) is throwing the same code! hopefully it goes away with a simple solenoid replace and hopefully wiring is ok.
The purple wire is the problem with those
Hello I'm trying to figure out where my silinoid hoses run too please help
Thanks so much for information , sir
I have 203 ford Xscape i just changed the egr & my check Angela light keeps coming on
Is the top round circle peice suppose to spin right and left? I noticed on my wife's car it'll spin easliy when I was doing some trouble shooting on terminal/contacts.
Yes they are designed to move.
Thanks.
Question adam I have an1409 EGR Vaccum Regulator Solenoid Circ I replaced it ran it for about 40 miles engine light came back on. What else can it be? Should I clear the code again and run it straight for 70 miles or plus. My other question after clearing the code can I do multiple ride cycles for code to reset or needs to be done in one driving cycle.
check the hoses probably leak
E scape?
Hey Adam I have a 04 Ford escape I noticed recently that my engine sounds a little louder than normal and shakes a little while driving.i am very loyal to my oil change every 90 days because I do alot of driving had a little work done on her recently.i had a coolant leak and a small oil leak.can that be the cause of my engine running louder
does this part make a ticking noise when its broke?
Ticking noise when it works
I got a 2003 Ford Escape v6 when I'm at a stoplight when it's in drive and I turn my AC on it drops idle and wants to die but if I turn my AC off it goes back to normal idle
hmm, I would start by checking the idle air control vale to make sure that is clean and working properly. it could also be something not communicating to tell the computer the ac is on and to compensate.
Will that make it idle high?
I have a 2003 model, I did that procedure to mine and start doing misfires. I had tu place back the original part back.
Was your new part an OEM/Ford/Motorcraft part? When sensors are involved, it is usually better to pay extra for a proven part. I've had to learn the hard way.
After the solenoid was replaced there was a squealing noise every time the engine was running.
another question Adam... what would happen to the car if left as is? just out of curiosity.. as mentioned on my previous comment, I have the same code (P1409) ... Thank you so much.
It's part of your emissions if it's stuck closed you just have higher pollutants if it's stuck open your car will run like crap. Either way your check engine light will be on.
Thank you so much! by "Run like Crap" do you mean poor fuel economy? and rough idling?
Mine is on... I'm noticing power seem less than normal (tad sluggish) and idle is a bit rough (no misfiring).
Almost forgot my MPG is 19.1 for last tank (when light came on) and I was getting closer to 20-21 before.
My engine started knocking and shit out on me because of a faulty egr valve apparently its common if not replaced
What is the connector just to the right of the solenoid?? I cant seem to figure it out!
Connected to whats seems to be a flat object..
Thats the egr solinoid.
@@adamanderson8631 thank you sir.. mine is so shorted out and melted/corroded up that its unrecognizable lol
I have an 06 Ford Escape. Im tired of throwing money into it can someone please help. This is what it is doing
The car start and drive great for 4 miles then it will stop pulling. U can turn the car off let it cool down and restart and it does the same thing all over. Please help!
catalytic converter is probably clogged
Has anyone had the p0800 exhaust valve control circuit high code? And fixed it? Please help Lol
Hey adam i replaced the solenoid and it actually made the rough idle worse, as tho the car wanted to die. Do you suspect it of being the wire, as well?
JJ Jetplane yes i would suspect the wire, it will look fine but the wire breaks right at the connector. I picked up a new connector at the local parts store.
Is it difficult to fix? Do i have to solder it on?
JJ Jetplane super easy i used a weather proof crimp connectors after i cut the old plug off.
Adam Anderson does the wiring break at the ecu connector or the connector for the valve itself?
@@adamanderson8631 Can you give me a part number for the solenoid connector. thnx.
I just replaced this and the engine light still is on
Check the wiring, it could be bad at the connector just like this one was. Also you may need to reset the check engine light or wait for a drive cycle for it to go out.
@@adamanderson8631 question I also replaced part engine light it’s on after driving like 45 miles engine light came back on.
How many miles would a drive cycle be.
Do I have to reset the engine light and begin a new drive cycle for engine light to reset.