Thanks for your insights. When I did this video I pulled down on the metal frame to get the holes aligned. You might have to alternate from one side to the the other to get the holes to line up. It is a tight fit Using an awl would work, as well, as long as you don't pry too hard and mess with the thread spindles the screws anchor to.
When putting the screws back in use an awl to align the holes . Especially on the latch side. The bar didn’t want to go down far enough
Thanks for your insights. When I did this video I pulled down on the metal frame to get the holes aligned. You might have to alternate from one side to the the other to get the holes to line up. It is a tight fit Using an awl would work, as well, as long as you don't pry too hard and mess with the thread spindles the screws anchor to.