Forge BOV for Hyundai Genesis Coupe 2.0T - FMDVHGA

Genracer.com shows you what is in the Forge Motorsport Blow Off Valve for the Hyundai Genesis Coupe 2.0T
Available Here at Genracer - www.genracer.co...
• Billet aluminum construction
• Viton silicone o-ring sealed piston-based internals - no diaphragm to fail
• 3 interchangable springs and included shims to adjust for varying boost levels
• P-ring sealed cap with swivel vacuum nipple
• Fully rebuildable
• Lifetime warranty

[@UberDAHnooB]

I have been trying to find out if the stock diverter on a 2013 would work on a 2011. Seeing that this bov works for both, is there a possibility of making an adapter so the older genesis can use the newer "replaceable" $40 part since you have to replace the whole unit on a 2011 if it fails?

[@girlskateboards625]

My 2014 gen coupe when I try to instal won't open up for some reason. I change the coil out to the yellow one but still can't figure out what's wrong.

[@steveperez4647]

Josh.E.Videos did you fix it

[@stepzyt3889]

Josh.E.Videos how did you change the spring?

[@neoda91]

got a forge value is stuck open wont close just happened today so im looking around what to do. tmmrw will open and grease and see if that works.

[@nelsonmampuya9714]

Same issue, please let me know if it worked and what you used!

[@neoda91]

hey nelson, funny thing is so i open the hood., the valve is open ofcoruse. i start the car. you can see the value is stuck open , i took a screwdriver or Philips head or something long. i tapped the back of it and it released the value that means it got stuck because less lube friction etc. i took some Spray lube turned off the car and sprayed the holes., start the car it worked and CEL light went off and i turned it off again lubed it again just to make sure and pumped some real hard revs and yeah so far so good. i know one day ill have to reopen it and lube it the spring

[@nelsonmampuya9714]

Thanks man, what spray lube did you use? I will use this temporary fix until I open it myself.

[@neoda91]

liquid wrench is fine they say wd40 but i wouldnt personally bc i know how that works on these types of parts, was very happy it was just stuck not something big.

[@jamiedang1301]

neoda91 so question real quick bought the same bov. So when I rev and let go of the gas it only opens up a little bit is that normal

[@djprez239]

i just got one
but i saw that when the car is off the BOV stay open
is that normal

[@ryuhadouken1404]

yes it's suppose to. shut the car off wait about 3-4 seconds and you'll hear a small pop, escaping of gas.

[@kamine67]

how would i know which spring to use?

[@GabeVlogss]

i would like to know this aswell. have you found out?

[@kamine67]

There are given boost numbers for different chims but I ended up trying out all of them and used whichever felt the best which ended up matching with the given boost table