Not going to lie man, spent way too long and some wasted filament trying to figure out if I needed a separate bracket for my CR touch before I found this video. Thanks my man! Extremely helpful.
Thank you for this video. I have an Ender 3 Max NEO. Should I install the Sprite firmware for the Ender 3 Max or for the Ender 3 S1 Pro? The S1 Pro uses the same Sprite extruder I purchased. Thank you again.
Ender 3 S1 pro is small bed size so never use that, first try using ur default firmware by changing the extruder steps. Wrong firmware could damage ur Printer so be careful.
The firmware i made has low print quality issue, i currently use the pre compiled marlin firmware form below link, it will ask for donation enter 0 and continue. Make sure check and change E steps and and probe offset. For sprite extruder. marlin.crc.id.au/
Месяц назад
@@TechRallyofficial which one? Ender 3 - BLTouch - SDCard? I couldn't find the file .bin
Not going to lie man, spent way too long and some wasted filament trying to figure out if I needed a separate bracket for my CR touch before I found this video. Thanks my man! Extremely helpful.
Thank you friend 😃
Thank you for this video. I have an Ender 3 Max NEO. Should I install the Sprite firmware for the Ender 3 Max or for the Ender 3 S1 Pro? The S1 Pro uses the same Sprite extruder I purchased. Thank you again.
Ender 3 S1 pro is small bed size so never use that, first try using ur default firmware by changing the extruder steps.
Wrong firmware could damage ur Printer so be careful.
Thank you for sharing the process, Do you know if I could use my BL touch instead of the CR Touch?
Yes, you can use BL touch
@@TechRallyofficial Thanks for the reply, just out of interest you wouldn't know what the off set would be with the BL touch??
Sry bro, i don't know the offset for BL touch
You can search in reddit there you can get some information
Could you provide the firmware you made? Thanks! This video is amazing.
The firmware i made has low print quality issue, i currently use the pre compiled marlin firmware form below link, it will ask for donation enter 0 and continue.
Make sure check and change E steps and and probe offset. For sprite extruder.
marlin.crc.id.au/
@@TechRallyofficial which one? Ender 3 - BLTouch - SDCard?
I couldn't find the file .bin
No, Select based on the version of your board.
Example. Ender 3 v 4.2.2 board witb BL touch.