You mentioned that your control was busted and you were going to fix it the next day. Just to clarify, you typically want to make sure your control is fixed BEFORE you adjust your traverse, correct? Or does it matter? I am working on a simple road topo that goes through a suburban neighborhood. There are a lot of power lines that threw off the H on the GPS when I set my first station. When I shot my backsight, I noticed a .1’ error on my H. Towards the end of my traverse, I check into mu control and the H is almost 1.0’ off. V was fine, though. Adjusting the traverse will NOT fix this problem. The initial control I set my total station on needs to be remeasured (this time with total station). THEN I can run a traverse adjustment.
Trying to follow your closurer... I put my start point in and close on a know without occupying... Just shooting into it... The collector stops on my point before... Never tried it before what am I doing wrong?
Hello ,my TSC 3 counteroller has a technical problem. Trimble Access has been removed. wifi and phone deactive. wifi manager does not work. please help me!🙏
Спорт
Good 👍
Does your measure topo (sideshots) get moved/rotated accordingly too? No point if the adjustment only moves the stations.
You mentioned that your control was busted and you were going to fix it the next day. Just to clarify, you typically want to make sure your control is fixed BEFORE you adjust your traverse, correct? Or does it matter?
I am working on a simple road topo that goes through a suburban neighborhood. There are a lot of power lines that threw off the H on the GPS when I set my first station. When I shot my backsight, I noticed a .1’ error on my H. Towards the end of my traverse, I check into mu control and the H is almost 1.0’ off. V was fine, though. Adjusting the traverse will NOT fix this problem. The initial control I set my total station on needs to be remeasured (this time with total station). THEN I can run a traverse adjustment.
Trying to follow your closurer... I put my start point in and close on a know without occupying... Just shooting into it... The collector stops on my point before... Never tried it before what am I doing wrong?
You really shouldn’t just check into one point. You should check into two known control points with an ending azimuth.
How you observe points for traverse
Hello ,my TSC 3 counteroller has a technical problem. Trimble Access has been removed. wifi and phone deactive. wifi manager does not work. please help me!🙏