2010 F150 rocker replacement, tomorrow weld bodywork and paint

[@andyjprice7492]

so, the hard part was getting the running board off? Isn't that the way it always goes?

[@metalartcustomsLLC]

Right , usually the prep that’s the hard part

[@michaelmeyer8372]

What welding machine and wire did you use

[@metalartcustomsLLC]

Miller 185 and .035 wire is what I normally run. 75/25 for the gas

[@JoelGonzales-vh1ve]

We’re did you get the replacement parts from

[@metalartcustomsLLC]

I believe I got these from key parts… it’s been a while

[@dannymiller4560]

How much does this cost?

[@metalartcustomsLLC]

Every job is different. Depends on the rust and repair panels availability and a lot of other variables

[@scottnickolas9593]

Well how much did this one cost?

[@codenamecompton8689]

I'd also like a price range between 0$-0$ rugs estimates.

[@metalartcustomsLLC]

@@codenamecompton8689 I think this one was like $3000 if I remember, it’s been a while

[@codenamecompton8689]

@@metalartcustomsLLC thank you for the wisdom and knowledge 🙏