Setting your RC Cars Gear Mesh by Gear Backlash

[@3SIfan86]

This is basically how I have been doing it for years. I remember overthinking it in the beginning and this is exactly the video that will help newcomers to the hobby, and the video I wish I had starting out haha. Thank you.

[@RCexplained]

Thanks for sharing!

[@colin1992]

Hy ryan, great video about backlash. Ive had issues trying to find a good meshing point myself, this video helps alot.

[@RCexplained]

Great to hear! Thanks Colin!

[@zonegamma8197]

i like technical jargon very good

[@xibidit]

i put a strip of paper in between the mesh and push it tight, tighten the bolts and pull out the paper.

[@mohdkhairulhidayatabdulrah4157]

Hi Ryan. Is good explanation and good knowledge 👍🏻👍🏻

[@RCexplained]

Hey, thanks for the comment! Glad you liked it!

[@mohdkhairulhidayatabdulrah4157]

RCexplained i have a question about motor timing and i already email you. If you free can you check the email i sent to you. Thanks

[@RCexplained]

Replied

[@RobytheFlorentine]

thanks, exactly what I needed....but for my lathe :-)

[@RCexplained]

Glad I could help!

[@mehmoodkhan275]

Sir I have 64 mm 12 blades EDF 3500 kV can its thrust is enough to fly jet with complete parts total weight 1kg I have 3s lipo battery can jet fly well

[@RCexplained]

Hello, it sounds under powered for a jet weighing 1kg. I would expect a 4s setup using a 3300kv motor to push around an 850gram plane at a decent speed. Your project also depends on the type of jet you have?

[@ebuku8643]

Yes unrelated but if a esc doesn't have a internal bec can I use a external bec?

[@RCexplained]

If an ESC does or does not have an internal BEC, you can still run an external BEC with the correct setup.

[@ebuku8643]

@@RCexplained thanks

[@LETUBME]

How can I email you with a question?

[@RCexplained]

Address is on the about page