Do you have any recommendations when it comes to 40 oz tumblers? I believe the issue is the auto focus when doing a full detailed wrap. Either the middle is perfect but the outer edges arent cut/ focused or vice versa. It's been a struggle. I was doing great with 20 oz tumblers. I have the xtool M1 20W
do you have any setting for the atomstack A20 for the coated tumblers that I can run a grid test im fairly new to this but I am having difficulty finding any real settings for this
I also have the x20 pro. Scoured the internet and found a great starting point. I dialed in and found my fastest and best looking results I used speed 740, power 28% and lines per inch LPI 450. It worked great for names. I'd have to lower speed slightly on more intricate designs.
We have a Xtool d1 pro 20W and use Lightburn but when we go to material test it’s only doing for cut not engrave. How did you do a test for engraving? Thanks so much!
Thanks for the vid.
Thanks for watching…
Thank you once again for your help
Thanks.. your very welcome
Do you have any recommendations when it comes to 40 oz tumblers? I believe the issue is the auto focus when doing a full detailed wrap. Either the middle is perfect but the outer edges arent cut/ focused or vice versa. It's been a struggle. I was doing great with 20 oz tumblers. I have the xtool M1 20W
If the cups are tapered, you will need to make adjustments for the taper. Focal change can cause variations
How do you get the 4 squares for the grid background on light burn? I see you and LA hobby guy have it and it’s very neat!
There are settings that enable the grid to be turned off. Look in software settings
@@TheClackShack perfect thank you so much!
do you have any setting for the atomstack A20 for the coated tumblers that I can run a grid test im fairly new to this but I am having difficulty finding any real settings for this
Power and speed tests are needed on tumblers. The coatings are very different, always get a test piece
I also have the x20 pro. Scoured the internet and found a great starting point. I dialed in and found my fastest and best looking results I used speed 740, power 28% and lines per inch LPI 450. It worked great for names. I'd have to lower speed slightly on more intricate designs.
Did you build your stand? Do you have the plans
I just built it as I went. Yes, I made it from some 2x4s and some luan.
We have a Xtool d1 pro 20W and use Lightburn but when we go to material test it’s only doing for cut not engrave. How did you do a test for engraving? Thanks so much!
At the bottom, change the material settings to engrave
did you know if ATOMSTACK R1 Laser chunk compatible with XTOOL m1 ??
I have never got hands on an M1, can’t say
@@TheClackShack thanks
do you have any type of plan for your stand i would like to build one for my x7 pro
Stand?
yes
@@TheClackShack
i just purchased a rotary chuck i liked your set up
@@TheClackShack
Do you have plans this riser box?
No, just some plywood and 2x4 frame
Would the R1 work with a Sculpfun S30 Pro Max 20W?
It should work with any machine that uses the standard stepper plug. As long as you are using lightburn, should work the same
Would that chuck be compatible with the D1?
Yes, either using an XTool cable or just plugging it into the stepper cable. It comes with an A and B type cable.