Good job like Always. But one thing is good to be mentioned. That step up or down circuit can get very hot. Using Hot glue to place it there is not good idea. It will fall off and move easily. Other than that the work is very clean
Good job good product But you didnt share any explanation, which part do you use... Which part and which power did you use for it. I know some, you use bms and power led but what ıs the middle part from bms to led? why do you use it? Is ıt led driver?
very nice but better if you make the collar holding the led adjustable in order to adjust your light from flood to more focus
Good job like Always. But one thing is good to be mentioned. That step up or down circuit can get very hot. Using Hot glue to place it there is not good idea. It will fall off and move easily. Other than that the work is very clean
Good job good product
But you didnt share any explanation, which part do you use... Which part and which power did you use for it. I know some, you use bms and power led but what ıs the middle part from bms to led? why do you use it? Is ıt led driver?
it's 12v. voltage regulator circuit
Waalaikumsalam warohmatullahi wabaarokatuh sipppp kediri jatim
Hello. Is fan cooler required for xhp90?
i don't know because i don't use xhp90
@@GiauDIY 10w power 3.3Amp size 9*9mm
Do you think 40*40 aluminum cooler will be enough?
@@ozanoloji1 I think you should look for bigger aluminum
❤️👍❤️ ❤️👍❤️ ❤️👍❤️ ❤️👍❤️ ❤️👍❤️
xhp70.2 can use 12v you may not need step up and step down
you just need 5w,10w,20w and 1-10ohm ceramic resistors
thank you for sharing
its for the cv cc or led will fry with to much current
@@CV-zl7zo using convoy xhp70.2 driver
@@CV-zl7zo theres some overcurrent protection on bms, just use bms with same specs with led.
Itu memakai pipa ukuran berapa inchi
Itu kaca nama nya apa