A manual Renishaw? I've never seen it at a Doosan before. Even the older q-setters are automaticly lowered by pressing the q-setter button, and that q-setter look identical to the ones I've used for the past years... 🤷 Is the motor for it gone bad or..?
Between my Lynx 220LSYC and my ST-15Y I find that getting used to the work flow I can setup both just about as quickly because you still need to jog the turret down with either. But I'll take a bit more involved setup for the extra power and notable rigidity of my doosan.
Very nice 👍
A manual Renishaw? I've never seen it at a Doosan before. Even the older q-setters are automaticly lowered by pressing the q-setter button, and that q-setter look identical to the ones I've used for the past years... 🤷 Is the motor for it gone bad or..?
You would be correct.. it is a manual pull down tool eye..
They have hydraulic ones and manual pull downs..
@@Blind_Reviews Nice to know. How many times have you pressed the q-setter button on the far right on the panel before you got used to it? 😂
Go Bills
Skipped some important info. You must be in Geo and check if x or z changes.
You would be absolutely correct... hopefully they read your comment lol
@@Blind_Reviews lol
It usually pops right to that screen on the doosan's I've been running.
This is like 20x slower and more complicated than on a Haas😮
Between my Lynx 220LSYC and my ST-15Y I find that getting used to the work flow I can setup both just about as quickly because you still need to jog the turret down with either.
But I'll take a bit more involved setup for the extra power and notable rigidity of my doosan.