Honda Accord Ignition Coil Pigtail Connector Replacement (2003-2007)(2.4L Engine)
HTML-код
- Опубликовано: 21 окт 2024
- This is a video on how to properly splice and replace your 2007 Honda Accord 2.4L 4 Cylinder engines ignition coil pigtail connector. A few symptoms of a bad ignition coil pigtail connector are: loss of power, check engine light on, poor fuel economy, backfiring, misfiring, hard starts, stalling, jerking and vibrating.
Link to parts and tools below:
Soldering Iron:
www.amazon.com...
Soldering Iron Wire:
www.amazon.com...
Wire Strippers
www.amazon.com...
Heat Shrink Option #1
www.amazon.com...
Heat Shrink Option #2
www.amazon.com...
Electrical Tape
www.amazon.com...
Literally THE MOST informative vid I have found on these. THANK YOU! You're a life saver!
@@bluerosegurl why thanks for watching and taking the time to comment. I really appreciate your feedback and I’m happy my video helped. Hope you’ll consider subbing to the channel.
Very smart to disconnect your battery neg. terminal before working on any parts on your car! 😺 Cool cat who drives a 2007 Honda Accord!
@@Carey-whut thanks and yes, safety first!
Thx for this video, my honda civic ex 2011 has the same problem and I couldn’t find any other video that showed so well what I need to do, my pigtail connectors are getting here next, I’m definitely coming back to watch this tutorial again
Hey thanks for watching and taking the time to comment I really appreciate it. I couldn’t find a video that showed this either so I decided to make my own for others that may have this issue so I’m very happy to hear my video is helping.
If the clip on my connector broke off , could I only change the plastic part of the connector or would I need the entire connector with the wires changed?
Hey thanks for watching. Sometimes you can get the little connectors out and replace just the plastic part but mine were so brittle they broke inside of the connector so I just spliced one on. Hope this helps and hope you’ll sub.
@@ucanfixit1 instead of splicing you could have de-pinned both connectors and stuck the same wires in the new connector and not splice anything
@@R00tOn3X couldn’t do it on mine the actual aluminum pins the wires go into were all bent, trust me I would rather go that route!
I got one but didn’t work I just tied it in the black and white wire on the other ones
@@blackent7513 hey thanks for watching. What do you mean it didn’t work? The pigtail or it didn’t resolve your issue?
Do you happen to remember what was the part number of the connectors? Or from where did you bought them?
Hey thanks for watching. I believe I purchased the pigtail connector from AutoZone.
@@ucanfixit1 Ok, thanks and by the way great videos.
@@yahdev5 Thank you I really appreciate it.
Can one connector being broken cause crank no start ?
Definitely, I’d start with fixing the connection then going from there if the issue still persists.