Got 92-20 airbag code in 04 accord. Replace the indicator with $27 Duralast Switch SW7578 from Autozone and solved the airbag light problem. Checkout old switch and found 103 ohm resistance was defective (open circle). Thank for the video.
I commented ago because I had this code on my 2012 Honda ex-l. Sir bag light was flickering off and on. Like you noted, the “off light” would not always turn on and that is when the airbag light went on. Finally got the hazard light switch switch replaced (was a little more difficult in the 2012 Honda Accord due to having to take out the whole center consul and I’m happy to say the light has stayed off!! $46 dollar fix compared to spending $1000s at the dealership. Thank you so much!
Thank you for the video. It helped me fix my problem. I took my switch apart and the issue was a bad solder on the 361 ohm surface mount resistor. Re-soldered it and it seems ok so far.
Thank you, this saved me $224 worth of “labor” at Honda, though unfortunately I overpaid for the switch and couldn’t escape the $150 “diagnostic fee” for plugging in the scanner and checking the codes 🤦♂️ I can’t believe how stupid easy this repair was!
All DIY mechanics should have a good code reader. Make sure it has ability to read ABS and SRS. and I wish mine had live scope. Bought mine off Amazon for 150$
Thank you so much I was looking ans looking until I saw your video. And fixed my problem. I run the codes. By jumping pins 4 and 9 in the OBD 2 connector. And airbag lights flash 9 slow times and 2 quick. Code was 9-2. Thqnk you very much
I had this code 92-20 Fault Airbag Code (Open or Short to ground in the passenger's airbag cutoff indicator and it worked perfectly for me in my 2010 honda accord Ex 4 cylinder, greetings from dominican republic.
Really I thank you very much for your help and your illustration. Although the bug is easy and nothing and could cost airbag capsules and more, but it's tricky. I thank you again. You are appreciated.
For anyone with an 8th gen civic, this fix can also work. The passenger airbag on light is supposed to be right above the flashers button but for me an aftermarket radio didn’t have the slot for the passenger airbag on module so it wasn’t plugged in. All I had to do was plug one in, clear the code and no more 92-2x.
I just fixed mine. There was corrosion on the solder points on the circuit board in the switch. I used isopropyl alcohol and scrubbed the points with a wire brush. I assume it was from condensation getting in the switch from the ac vents being next to it.
Funny enough, this code was being thrown in my 2011 Ford Crown Vic. Turns out like you said “passenger side light short” I just took it out and blew on both sides and it went away... lol.
I have a 92-21 code on my CR-Z but I assume its the same thing because my airbag indicator light sometimes doesnt turn on. Gonna get a new one and I hope it fixes it
Hi, thanks for good video. I have the same code on my 2005 honda odyssey. One thing that comes in my mind is, have you checked that broken bulb is not causing this? Then it would be even easier fix just to replace the small bulb.
Hi Nemiers , Thank you for your feedback. The light works OK . The problem is not with the light . The problem is with the module it self from inside. I am glad that you find this video helpful. Thank you for your feedback .
@@autorepairchamps ok, then it is more interesting to take it apart and see what could be the real cause. I would just buy new one, but as I am living in Europe these inexpensive parts tend to get expensive with shipping and tax. Thanks!
@@autorepairchamps ok, then it is more interesting to take it apart and see what could be the real cause. I would just buy new one, but as I am living in Europe these inexpensive parts tend to get expensive with shipping and tax. Thanks!
Totally understand, Try to find a junkyard nearby or Ebay, here is a link where you can get one from ebay here is a link www.ebay.com/i/132838893311 Good luck my friend. Thanks
@@autorepairchamps thank you I have the same problem on my Honda Accord 2007 I bought used and when I went to the dealer he just looked at it and said it has been in accident and I think he was lying
If you are getting the same code , try the trick mentioned in the video by plugging the seat belt in and see if the light is gone . if light is gone then yes the fix is going to be the seat-belt buckle . Let me know if you have any other questions .
@@HumanStateOfEmergency You may need to re-calibrate your weight sensor on the passenger seat. you will need to attempt this with a scanner to reset your weight settings .
![Felix "Unfair" | [Stray Kids : SKZ-PLAYER]](http://i.ytimg.com/vi/Oswujxm2Ag0/mqdefault.jpg)
Got 92-20 airbag code in 04 accord. Replace the indicator with $27 Duralast Switch SW7578 from Autozone and solved the airbag light problem. Checkout old switch and found 103 ohm resistance was defective (open circle). Thank for the video.
I commented ago because I had this code on my 2012 Honda ex-l. Sir bag light was flickering off and on. Like you noted, the “off light” would not always turn on and that is when the airbag light went on.
Finally got the hazard light switch switch replaced (was a little more difficult in the 2012 Honda Accord due to having to take out the whole center consul and I’m happy to say the light has stayed off!! $46 dollar fix compared to spending $1000s at the dealership. Thank you so much!
You are welcome - Thanks for sharing !
Any video you found for 2012? I’m noticing the same problem on a 2012 accord that I’m trading my 06 for
How did you get the hazard light out dude?? I’m in a 2012 too and I’ve taking my the entire radio out. Still can’t get the hazard button off
Thank you for the video. It helped me fix my problem. I took my switch apart and the issue was a bad solder on the 361 ohm surface mount resistor. Re-soldered it and it seems ok so far.
Thanks bro same thing on my Honda fixed 😊
Thank you, this saved me $224 worth of “labor” at Honda, though unfortunately I overpaid for the switch and couldn’t escape the $150 “diagnostic fee” for plugging in the scanner and checking the codes 🤦♂️ I can’t believe how stupid easy this repair was!
All DIY mechanics should have a good code reader. Make sure it has ability to read ABS and SRS. and I wish mine had live scope. Bought mine off Amazon for 150$
Thank you! This fixed my issue. The button itself was out of position behind the trim. I fixed it back in place and plugged it back in and it worked!
Great job. Really good for first video. Had to buy an expensive scanner and this is the code (92-20)that came up. Thanks again
I had this problem. This video was the fix! thx man!!
Glad You found this Video helpful - My pleasurer .
Dealer in Southern California wanted $440 to replace on a 2005 Accord. Saved my friend a TON of money!
Thank you so much I was looking ans looking until I saw your video. And fixed my problem.
I run the codes. By jumping pins 4 and 9 in the OBD 2 connector. And airbag lights flash 9 slow times and 2 quick. Code was 9-2. Thqnk you very much
Thank for sharing your experience . I appreciate you taking the time to post your experience and share it with us .
I had this code 92-20 Fault Airbag Code (Open or Short to ground in the passenger's airbag cutoff indicator and it worked perfectly for me in my 2010 honda accord Ex 4 cylinder, greetings from dominican republic.
Really I thank you very much for your help and your illustration. Although the bug is easy and nothing and could cost airbag capsules and more, but it's tricky.
I thank you again. You are appreciated.
Thank you for your feedback, I appreciate you taking the time to share your feedback. Thank you
Great video. Thanks for explaining everything in detail. Very informative.
Glad it was helpful!
For anyone with an 8th gen civic, this fix can also work. The passenger airbag on light is supposed to be right above the flashers button but for me an aftermarket radio didn’t have the slot for the passenger airbag on module so it wasn’t plugged in. All I had to do was plug one in, clear the code and no more 92-2x.
Excellent work. Will be trying this soon.
Best of luck!
Love it thanks for the video!!! From Chicago!!!
I just fixed mine. There was corrosion on the solder points on the circuit board in the switch. I used isopropyl alcohol and scrubbed the points with a wire brush. I assume it was from condensation getting in the switch from the ac vents being next to it.
Thanks!
John , Thank you for your support . I greatly appreciate it .
The same problem with my 05 acura rl but the switches are different. Nice vid it help a lot
You are Welcome my friend
Would you please to show the part that needed to pry open? Don't want to pull the wrong part and breaking it in the process. thx
This was extremely helpful thank you!
Funny enough, this code was being thrown in my 2011 Ford Crown Vic. Turns out like you said “passenger side light short”
I just took it out and blew on both sides and it went away... lol.
Wow That is very interesting. Honda And Ford . Ummm yeah. Anyways Thanks for sharing . Much Appreciated it . I learn something new everyday :)
I have a 92-21 code on my CR-Z but I assume its the same thing because my airbag indicator light sometimes doesnt turn on. Gonna get a new one and I hope it fixes it
I have the same problem airbag on i put my OBDII and I got this code 87-32 side airbag cutoff indicator stays on/off ?
Thank you your video was very helpful
👍
So easy. Honda asking $400 to do this job 😑 think I’ll just tackle myself. Thanks for video!
You are welcome :)
Hi, thanks for good video. I have the same code on my 2005 honda odyssey. One thing that comes in my mind is, have you checked that broken bulb is not causing this? Then it would be even easier fix just to replace the small bulb.
Hi Nemiers , Thank you for your feedback. The light works OK . The problem is not with the light . The problem is with the module it self from inside. I am glad that you find this video helpful. Thank you for your feedback .
@@autorepairchamps ok, then it is more interesting to take it apart and see what could be the real cause. I would just buy new one, but as I am living in Europe these inexpensive parts tend to get expensive with shipping and tax. Thanks!
@@autorepairchamps ok, then it is more interesting to take it apart and see what could be the real cause. I would just buy new one, but as I am living in Europe these inexpensive parts tend to get expensive with shipping and tax. Thanks!
Totally understand, Try to find a junkyard nearby or Ebay, here is a link where you can get one from ebay here is a link www.ebay.com/i/132838893311 Good luck my friend. Thanks
I need this switch for a 2009 civic lx. How can I find it? Can anyone help?
Should we unplug the car battery before doing this?
Yes
Hi, please what machine did you use to read the airbag code?
@I M , I used Autel MaxiCheck Pro - Airbag / ABS
I’m having 92-2 after spilling some fluid on the seat on my tl. Seems strange to replace something on the dash but I will try. Any other suggestions
ATG suggests to remove the Seat-belt Latch (Press) & clean the Microswitch with ATG Gold Cleaner.
Did you have an accident in this car before you have the light on?
No , the 4 way flasher switch went bad and this is is common problem for these model vehicles
@@autorepairchamps thank you I have the same problem on my Honda Accord 2007 I bought used and when I went to the dealer he just looked at it and said it has been in accident and I think he was lying
@@abodalashkar5686 So you replaced the switch all working ok now ?
@@autorepairchamps no I haven't I am looking for the right part number so I am going to open it and check the number first than buy the part
Hey i wanted to know if this would also apply for a 09 civic
If you are getting the same code , try the trick mentioned in the video by plugging the seat belt in and see if the light is gone . if light is gone then yes the fix is going to be the seat-belt buckle . Let me know if you have any other questions .
Great Video!!
But I don’t know if I’m hearing right but this guy got a Caribbean accent 🤔
Damn should have watch this video so i dont wast 355 to fix this crap.acura fk me up good
Ouch - Sorry Dude !
Thanks.
You are welcome
Anyone still having problems the part # 35510-SDA-A11
My airbag light actually comes on when I turn on the car
what code are you getting ?
@@autorepairchamps 83-22 passenger weight sensor
@@HumanStateOfEmergency You may need to re-calibrate your weight sensor on the passenger seat. you will need to attempt this with a scanner to reset your weight settings .