Husqvarna chainsaw chain spinning at idle repair with no special tools, 435, 440 etc

Link to the clutch used in this video: amzn.to/3kz9e9Z (make sure to confirm that it FITS your model!!!!)
In this video I show you two ways to make get that chain to stop spinning at idle if you have already set the idle to correct RPM and it is still spinning!
Here's a video on setting the idle (its on a ryobi 2 cycle pole saw but the principle is the same on chainsaws as well)
• DIY Ryobi Expand-It 2 ...
Now if you try to do this and you cannot get the chain to stop spinning with a reasonable idle speed, then you will have to proceed to these next steps.
As an amazon associate I earn from qualifying purchases at no additional cost to you! Thanks

[@bolokraymond3190]

Thanks, hopefully this helped.

[@danielpadgett2831]

Also need to gease the needle cage bearing very important

[@Channel0002]

Nice video. Couldn’t you use an impact drill with the actual clutch removal socket to take that clutch off and that way you wouldn’t need to remove the spark plug and put the rope in the cylinder??

[@mainelysmallengineDIY]

Yes! For sure if you have one.

[@henryp1806]

P R O M O S M ❣️