Making of SSTC Proto v3 Driver PCB + First Run

[@theod0r3]

Very nice!

[@index4455]

Hi, let me tell you that you made an awesome job, is there any possibility of sharing the schematics? i cant see the components in the video.

[@GianniLaschi]

on FB

[@index4455]

oh, ok, i will look for it then, thx!

[@Mr11223marc]

Nice! what's resonant frequency?

[@GianniLaschi]

look at 13:20 ;)

[@Mr11223marc]

Ah ys, not watched it! 234 khz ! thx :P

[@HaroldVictor1911]

will you upload these file on google driver or something ?

[@GianniLaschi]

i share the Schematics, but for PCB is different, there is so much work on it

[@HaroldVictor1911]

about the feedback pin , how you use it ? antenna , or use feedback transformer ?

[@GianniLaschi]

CT , one lead to gnd driver, other lead goes in series to a 100n cap then a 1k resistor then to the feedback input

[@PlasmaEagle]

Hi , how many turns?​@@GianniLaschi

[@kisslove7219]

I apologize, I'm new to this topic electricians! from the Deaf village, but everything that is connected with Tesla, I understood, must be grounded with earth (there to connect with a minus)))) Council Dunno))

[@GianniLaschi]

Hello, the secondary coil bottom is connected to ground, the wire pass trough a Transforer toroid core (CT) to take the signal feedback