I haven’t used a manual machine in a very long time. I would imagine it would be the same as doing an alignment on a cnc type but you would have to just move the probe by hand. Thanks!
For the manual alignment will the cmm compensate for height changes based off of fixturing? Say I com back to a set of parts after 6 months and I do not use the exact stanchions that had been previously used. Thank you this has been a great video series you have produced.
As long as you do an alignment before you start measuring you should be good. The initial alignment will set the plane height even if you use different height stanchions. Thanks for asking!
Part alignment process for making a program to measure different parameters
Sir how to measure flatness perpendicularty and roundness plz make a video on this topic
this great thank you very much. do you have a video showing how to write an alignment program on a manual machine.
I haven’t used a manual machine in a very long time. I would imagine it would be the same as doing an alignment on a cnc type but you would have to just move the probe by hand.
Thanks!
Can you show how you did in the screen software?
For the manual alignment will the cmm compensate for height changes based off of fixturing? Say I com back to a set of parts after 6 months and I do not use the exact stanchions that had been previously used. Thank you this has been a great video series you have produced.
As long as you do an alignment before you start measuring you should be good. The initial alignment will set the plane height even if you use different height stanchions.
Thanks for asking!
Is there a way to rotate the probe with the joystick? Moving it 90 degree angles etc?
If it is I don’t know how to. I’m not saying you can’t but I’ve never been shown how.