I have the same sickle bar and I replace my blades from Rural King and just drill both holes just a bit bigger and they went in and worked just fine. at the same time I alway have to replace the bearing too
Can you angle the cutter below horizontal (like to trim around a pond) and if so approx what angle down will it go? For instance, the $$$ ones will go -45 degrees. Thanks
If I may 6:46 crescent wrench,,, good idea Hammer no maybe not ,, my suggestion punch that will fit through hole AND try Before you remove sickle good luck
I have the same sickle bar and I replace my blades from Rural King and just drill both holes just a bit bigger and they went in and worked just fine.
at the same time I alway have to replace the bearing too
Where do you buy the bearing?
Can you angle the cutter below horizontal (like to trim around a pond) and if so approx what angle down will it go? For instance, the $$$ ones will go -45 degrees. Thanks
This one only goes flat. Negative angles would be nice, though!
If I may 6:46 crescent wrench,,, good idea
Hammer no maybe not ,, my suggestion punch that will fit through hole
AND try Before you remove sickle
good luck