SMPS REPAIR led lcd tv - smps

#smps #repair #ledtv #smps_repair #inverter In a switched-mode power supply (SMPS), the AC mains input is directly rectified and then filtered to obtain a DC voltage. The resulting DC voltage is then switched on and off at a high frequency by electronic switching circuitry, thus producing an AC current that will pass through a high-frequency transformer or inductor. Switching occurs at a very high frequency (typically 10 kHz - 1 MHz), thereby enabling the use of transformers and filter capacitors that are much smaller, lighter, and less expensive than those found in linear power supplies operating at mains frequency. After the inductor or transformer secondary, the high frequency AC is rectified and filtered to produce the DC output voltage. If the SMPS uses an adequately insulated high-frequency transformer, the output will be electrically isolated from the mains; this feature is often essential for safety.
Switched-mode power supplies are usually regulated, and to keep the output voltage constant, the power supply employs a feedback controller that monitors current drawn by the load. The switching duty cycle increases as power output requirements increase.
SMPSs often include safety features such as current limiting or a crowbar circuit to help protect the device and the user from harm.[1] In the event that an abnormal high-current power draw is detected, the switched-mode supply can assume this is a direct short and will shut itself down before damage is done. PC power supplies often provide a power good signal to the motherboard; the absence of this signal prevents operation when abnormal supply voltages are present.
Some SMPSs have an absolute limit on their minimum current output.[2] They are only able to output above a certain power level and cannot function below that point. In a no-load condition the frequency of the power slicing circuit increases to great speed, causing the isolated transformer to act as a Tesla coil, causing damage due to the resulting very high voltage power spikes. Switched-mode supplies with protection circuits may briefly turn on but then shut down when no load has been detected. A very small low-power dummy load such as a ceramic power resistor or 10-watt light bulb can be attached to the supply to allow it to run with no primary load attached.
The switch-mode power supplies used in computers have historically had low power factors and have also been significant sources of line interference (due to induced power line harmonics and transients). In simple switch-mode power supplies, the input stage may distort the line voltage waveform, which can adversely affect other loads (and result in poor power quality for other utility customers), and cause unnecessary heating in wires and distribution equipment. Furthermore, customers incur higher electric bills when operating lower power factor loads. To circumvent these problems, some computer switch-mode power supplies perform power factor correction, and may employ input filters or additional switching stages to reduce line interference.
Thank you !! for watching , like , comment and share my videos.
Please subscribe my channel to get daily new videos

[@powerwold8625]

Good video

[@chamilathuduwage7646]

Most Valuable information.Thank you. Good Luck.

[@amatech99]

Thanks and welcome

[@flowerswe9836]

Wawoow nice and good learning video

[@MSELECTRONIC]

Video eka supiri sir lokudeyak igena gaththa me wage Dewal kiyanawata godaaak pin sir bs jayawewa 👍👍👍👍🙏🙏🙏🙏❤️❤️❤️❤️

[@amatech99]

❤️❤️❤️

[@shankurunegala7550]

good sir

[@amatech99]

❤️❤️❤️❤️

[@amilanuwan2710]

💐💐💐💐
❤️❤️❤️❤️
👍👍👍👍

[@makytatoo663]

Great job sir ❤️❤️

[@chamikakeshan9067]

Thanks ...💯🙏🙏👍

[@lovesafe457]

Great job good video and good channel 👌👌

[@SamanthiWikramasungha-yy7op]

සුපිරි 👍බලන හැමෝම ලයික් කරමු යාලුවනේ

[@amatech99]

ස්තුතියි ❤️❤️

[@shanduminda2957]

නියමයි අයියේ 🔥🔥🔥❤🙏

[@amatech99]

❤️❤️❤️

[@mudithamadushanka8288]

sony Klv32t400a eke kohomada on karaganne

[@sanathdushmantha9253]

Sir samsung crt tv ekak rupa hodatama penawa sound no clear

[@sajithroshan9644]

Aiya singer crt tv akea screen akea pathakata gehin wam pathen kalu erak teyenawa butoon abuwata menu akea aneth ne volume wade wanawa ath screen akea volume adu wade wenawa penaneth ne chanel maru karata chanel anka penaneth ne

[@rsanus762]

Sir podi getaluwak mage tv eka smps eke 13 v eka enna ne mokada getaluwada danne

[@dumindasagara2857]

32 inch damro smart tv eke back light blink wela off wenawa pl help me

[@amatech99]

මුඉන්ම බැක් ලයිට් ඩ්‍රයිවර් එක සහ බැක්ලයිට් පටි බලන්න

[@sanjayawejesingha3135]

වීඩියෝ එක ප්ලේ වෙන්නෙ නෑ

[@amatech99]

හැන්දැවේ 4පස්සෙ ප්ලේවෙනවා