Appreciate the video! Now I can go work on my 94, been sitting for like a year, already did starter and alternator and just runs terrible so Im hoping the dizzy is off and I can use the method you showed us
Hello there, I just acquired a 92 mighty max for free not sure what is wrong though they told me the mechanic said it wasn't worth it. Ive got time to repair it and would enjoy seeing more video's and hear your thoughts on different problems.
Hey question im replacing my distributor on my mighty max where did you get yours from ? Mechanic says autozone has the wrong one my cord seems too short how long was your plug ?
I went through all this its easy...im no professional but those 2.4s are simple and rock solid. Other than valve seals and at 250000 miles oil rings can get weak and shes use oil
Got mine to start after 5 years of sitting. Ran for a minute revved real high so i turned it off now it wont start. Prior to starting tank was cleaned out and fresh gas out in. Still in timing and has spark. Any ideas?? Also cant get it to start with starting fluid anymore either
Can you tell me how I can remove the driver side balance gear I need to replace the seal behind it and it just spins any tips ? ( I’ve tried with belt on as well)
I'm buying a v6 mighty max this weekend. The owner sent me a pic of the new belt they installed after it blew a head gasket and I see that the passenger side is off by 6 teeth. They tell me they can't get it to start. Do you know if the 6g72 an interference motor?
Mine does the same thing it cranks but doesn’t start I changed fuel pump and check the pressure do you think it’s the old gas and what should I do drain. It and put new gas ?
Alvaro Sotelo consider looking into the main relay located on the passenger foot panel area along side the main ecu they tend to go bad , changed it on mine started right up after changing distributor, fuel pump, spark plugs & wires
Hey man, great video. Didn't know about that trick with the dizzy. However, I tried doing that but couldnt get it to go in without my rotor turning. Also, I've set my timing marks about 200 times on my 94 and it still runs like total shit. Sometimes I can get it to time up and run but it misfires like crazy.
Justo el problema que tengo en este momento no puedo subir de tiempo más que a ( 0 TDC ) mañana estaré poniendo a tiempo las marcas del distribuidor. La camioneta lleva trabajando así más de 7 años! De los cuales se dejó de realizar servicio ya que perdía potencia.
So that tick is the lifter? Mine does the same sound,I recently bought if from some idiot in my town,and he over torqued the drain plug so he stripped the oil pan,
Yea you can get the lash adjusters on amazon for about $2 each if you buy them in a 24 pack. That works out to 3 sets for the truck engine. That is cheaper than you can get a single set for at a parts place or the dealer.
The lifters are easy, you just pull the rack off the top the valve train and stick them in there.. I will be doing one soon as I am about to replace the head on one of my trucks but I am in the process of moving into a house we just purchased so that project has gotten pushed off a bit..
Thanks for this . I bought one and i really need to understand all this, thanks again
Appreciate the video! Now I can go work on my 94, been sitting for like a year, already did starter and alternator and just runs terrible so Im hoping the dizzy is off and I can use the method you showed us
Thanks brother gives me a better idea how to set timing marks on my mighty max
thank you so much this helped me on my dodge d50 as far as the distributor and i got her running again thanks a ton :D
Do you have to set the gravity on the oil pump with the mighty max as i see others do when setting the oil pump at its mark on other 4G63 engines.
Great video. Subscribed. I have 2 Mighty Max, 87 carbed and 93 efi. They are not the easiest cars to work on!
1986 Mitsubishi 2.6 mookini carburetor
1994 2.4L efi
Hello there, I just acquired a 92 mighty max for free not sure what is wrong though they told me the mechanic said it wasn't worth it. Ive got time to repair it and would enjoy seeing more video's and hear your thoughts on different problems.
Awesome video bro bro I really appreciate the help
Great video Sam. I'm working on my uncle's Mighty Max today. This is Austin from Ram Powell. Good job!
Hey question im replacing my distributor on my mighty max where did you get yours from ? Mechanic says autozone has the wrong one my cord seems too short how long was your plug ?
Never see a cluster like that on a Migthy Max with tachometer
2.6L engine, does the carb need to be removed to replace the fuel pump ?
Tank you help me a lot
I went through all this its easy...im no professional but those 2.4s are simple and rock solid. Other than valve seals and at 250000 miles oil rings can get weak and shes use oil
Got mine to start after 5 years of sitting. Ran for a minute revved real high so i turned it off now it wont start. Prior to starting tank was cleaned out and fresh gas out in. Still in timing and has spark. Any ideas?? Also cant get it to start with starting fluid anymore either
Can you tell me how I can remove the driver side balance gear I need to replace the seal behind it and it just spins any tips ? ( I’ve tried with belt on as well)
I'm buying a v6 mighty max this weekend. The owner sent me a pic of the new belt they installed after it blew a head gasket and I see that the passenger side is off by 6 teeth. They tell me they can't get it to start. Do you know if the 6g72 an interference motor?
Thank you sir!
Great job and thanks for the video buddy I'm subscribing!!!
Respect
My dad has a mighty max 89 and I'm trying my best to get it going b4 he throws in the trash im hoping it's the timing
Where are you from brotha?
Does your distributor use points and condenser? I'm looking for some alternative to the points system.
It is like mine and it doesn't have points and condenser.
Is it the same on a 1990 mighty max micro cab?
Mine does the same thing it cranks but doesn’t start I changed fuel pump and check the pressure do you think it’s the old gas and what should I do drain. It and put new gas ?
What is your fuel pressure?
Are you getting spark?
Alvaro Sotelo consider looking into the main relay located on the passenger foot panel area along side the main ecu they tend to go bad , changed it on mine started right up after changing distributor, fuel pump, spark plugs & wires
How can I adjust the clutch wire on a 92 ram 50?
Just tighten up the nut to the clutch cable that goes into the firewall
Would this be the same for a 1995
Hey man, great video. Didn't know about that trick with the dizzy. However, I tried doing that but couldnt get it to go in without my rotor turning. Also, I've set my timing marks about 200 times on my 94 and it still runs like total shit. Sometimes I can get it to time up and run but it misfires like crazy.
Comm'on Monique, hit it again!
What's the actual name of these engine I'm having trouble finding it out
It’s a 4g64
hi Samuel, does the carburetor need to be removed to replace the fuel pump on the 2.6L engine ?
I need help, my mitsubishi migthy max 94 truck fails to demand more speed, the abacus to fix its engine
Justo el problema que tengo en este momento no puedo subir de tiempo más que a ( 0 TDC ) mañana estaré poniendo a tiempo las marcas del distribuidor. La camioneta lleva trabajando así más de 7 años! De los cuales se dejó de realizar servicio ya que perdía potencia.
So that tick is the lifter? Mine does the same sound,I recently bought if from some idiot in my town,and he over torqued the drain plug so he stripped the oil pan,
Yea you can get the lash adjusters on amazon for about $2 each if you buy them in a 24 pack. That works out to 3 sets for the truck engine.
That is cheaper than you can get a single set for at a parts place or the dealer.
You cant adjust those lifters on the 2.4 only the 2.0 and 2.6
Best to just buy the lifters on rockauto
How much you pay
Can you do a lifter change????? I could use the help
The lifters are easy, you just pull the rack off the top the valve train and stick them in there..
I will be doing one soon as I am about to replace the head on one of my trucks but I am in the process of moving into a house we just purchased so that project has gotten pushed off a bit..
Bro my l200 1992 1.6 still no ignition..
Cómo poner a tiempo el motor distribuidor del motor Mitsubishi a gasolina 2003 que está en el vídeo traducido al español
Still sounds out of time...
I did what u did and nothing is thire something I’m missing