Great guide, thank you. I'm adding the same kit to the same bike and this is very helpful. I plan to install the controls on the handle bar using a 1/4in by 1in u-clamp. Seems to fit very nicely next to the left side controls. The tips about the auxiliary power connector is very much appreciated as well... thanks again!!
Thank You - Great Video and very helpful! One question: How did you mount three square control box? I really like the location, but don’t see any bolt/mounting points on my T7 left of the instrument cluster. Thanks again!
Great guide, thank you. I'm adding the same kit to the same bike and this is very helpful. I plan to install the controls on the handle bar using a 1/4in by 1in u-clamp. Seems to fit very nicely next to the left side controls. The tips about the auxiliary power connector is very much appreciated as well... thanks again!!
what if you want to install auxillary lights and heated grips? Should you plug the wire in the same connector or split the wire harness?
For lights you can use the 2-pin adapter. That's how I installed two Baja lights.
Wire coat hangers work great too. Golf club grip solvent and the hanger and grips come off reusable.
Good video. Thanks for sharing this content.
I see you clean your bike as much as I do
Thank You - Great Video and very helpful! One question: How did you mount three square control box? I really like the location, but don’t see any bolt/mounting points on my T7 left of the instrument cluster. Thanks again!
How's the glue holding up?
You should start a heated grips installation company 😊
I could try some Ducati Scrambler SixtyTwo grips too!
nice video, thanks. What levers are you using please?
Very good instruction. Thank you!
Thanks! Glad it helps 😊
For the left side you can use air compression to get off
Great video. How did you position the controller next to the dash?
Ignore that I can see now…
really, how???
@@kefallinosit’s attached to the bolt to the left of the dash unit.
Use compressed air. Much easier.