Steering Wheel and Airbag Removal - Peugeot 206
HTML-код
- Опубликовано: 5 окт 2024
- How to remove and replace the steering wheel and airbag on a 2002 to 2009 Peugeot 206. WARNING: Attempt this fix at your own risk. Working on or near the airbag unit could be very dangerous so use extreme caution !. Disconnect the battery at least 30 minutes before you begin, to disable the airbag system, and leave it disconnected until the work is fully completed. After you disconnect the airbag connectors, do NOT probe the airbag terminals or connectors with a test meter as this could risk triggering the airbag. If you are in any doubt, take the car to a Peugeot specialist or garage and have a fully qualified mechanic carry out the procedure. Thanks for watching. Please comment, like and subscribe !.
All of my uploaded material is protected under copyright law. None of my videos may be re-uploaded, reproduced or transmitted, in part or in full, in any form or by any means, without the written permission of the copyright holder.
© / screwsnutsandbolts 2022
Read important information below:
Disclaimer
Under no circumstances will Screwsnutsandbolts be responsible or liable in any way for any content, including but not limited to, any errors or omissions in the content, or for any loss or damage of any kind incurred as a result of any content communicated in this video, whether by Screwsnutsandbolts or a third party. In no event shall Screwsnutsandbolts be liable for any special, indirect or consequential damages or any damages whatsoever resulting from loss of use, data or profits arising out of or in connection with the availability, use or performance of any information communicated in this video. Due to factors beyond the control of Screwsnutsandbolts, it cannot guarantee against improper use or unauthorized modifications of this information. Screwsnutsandbolts assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Screwsnutsandbolts recommends safe practices when performing any do it yourself repairs and or with tools seen or implied in this video. Due to factors beyond the control of Screwsnutsandbolts, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Screwsnutsandbolts. 
Авто/Мото
Probably THE best instruction vid I've seen. Clear and easy to follow...you can't ask for anything more than this.
Thanks for taking the time to record and upload this!
Thanks for watching !
Best channel for peugeot 206 service, appreciate your effort.
Thanks very much :)
First class video, ultra clear and precise. Thanks for the information :)
Thanks for watching !
My car has the same locking method as your car. I Attempted to remove the airbag, but was unsuccessful. I didn't know what was the problem, because I didn't know the working principle of the lock. Through your video, I found out that I didn't have enough pushing force. Thank you~
You're welcome !
very clear instructions and to the point..great idea about refitting the bolt to stop you nutting yourself with the wheel 😃
Thanks for watching !
This is the first time I've ever seen this done on Video.Good to watch and learn.I learned the hard way re the bolt on the steering wheel.....I took the bolt completely off on my old Vaux Cavalier . Yes ,it hurt when the wheel came off and hit my face LOL .Hope you are well.Thanks for the invaluable information in regard to personal safety 🥲
Thanks Mark :)
Very useful. This helped me for wheel alignment on my 206. Thank you.
You're welcome, thanks for watching !
Definetely, most useful video on yt. Saved me a lot of time.
Thanks for watching !
My best teacher 😃👍👍👍👍👍
Thank you! 😃
Great video and great help :) Thanks!
You're very welcome
Excellent video !
Thank you very much!
Sehr gut ,danke für das Hilfe.
LG,
Thanks for watching !
Super Video, Thanks
You're welcome, thanks for watching !
Thank you man
You're welcome 👍
Sehr gut gemacht, danke!
Thank you for watching !
Great video thanks 👍 super clear. I just realised that the replacement clockspring unit that I bought is missing one of the two main airbag cables (the right one). Unfortunately the replacement unit was sitting in my garage for a while and too late to return to the seller. I don’t suppose that its possible to open up the clockspring units so I can transfer the missing cable from the old one to the new one?
(the airbag cables come from the inside the clockspring unit, and the whole reason I did this job is the indicator wasn’t working reliably - faulty indicator switch.)
I don't know if you can even open the clockspring to be honest.
شكرا
Ive replaced the indicator unit but the headlights arent working properly? No side lights at all. Any suggestions? Your vid was really helpful.
Were they working with the old indicator unit ?
I need to do this on a Citroen C1 but apprehensive about messing it up.
Will I need a heavy duty torx bit + wrench, or will I be OK with something in a more 'consumer' price range?
Useful video - thank you. :)
You're welcome. You should be ok with a consumer range torx bit
@@screwsnutsandbolts Thank you - biggest fear is that I'll let the airbag off or something or sheer the bolt or something else stupid -- but I guess it's just beginner nerves. :)
Just make sure you disable the airbag using the proper procedures and take your time. The process might be different on a Citroen so if you're in any doubt, take it to a garage.
What is the size of the torx tip? T50?
Yes it's a Torx T50. I meant to add that into the video :)
I thought about changing my steering wheel and adding the one from new 208 model. Is it possible?
I'm not sure to be honest, sorry
Owsome
Thanks !
Hey. My Airbag Warning light is On after this. Do u know what i can do ?
mine also...
have a 307 but was identical only that he finally says immobilizer is disabled and the car can no longer start. Do I have to reprogram the key?
My steeringwheel does not have a hole on the bottom…? How do I do
What type of car ?
@@screwsnutsandbolts Peugeot 206 2001
@@hermanandersson7753 Does it have an airbag in the steering wheel ?
@@screwsnutsandbolts yes, it says “AIRBAG” on the steering wheel
@@hermanandersson7753 Maybe your steering wheel is a bit different since it's a pre-facelift model. Try to find a video posted by GXsub.
Hi. A mechanic changed the steering wheel air bag module. The face of the one he's changed it to is a different colour. I have the old one that is the right colour and looks brand new. Can you remove just the finished face and replace the bad one with the better one? I see it has side tabs all around it. I wondered if it's possible to get these off without damaging the module or it going off? Many thanks.
I don't actually know. I would not take any chances taking parts off the old one. It could be very dangerous
@@screwsnutsandbolts Fair warning cheers. I did think that.
I replaced the com unit and now I get a screeching noise whenever I steer. Also the airbag light came on permanently. Ive checked the connections and everything seems ok. Do you have any ideas?
Is the screeching noise coming from the com unit ?
@@screwsnutsandbolts yeah
Hello, what is the grey module? Is that for horn?
Yes it is
👍👍👍👍
Thanks !
What is the reason for the peugeot 2o6 airbag light to come on
Same
I have "airbag fault" and "passenger airbag deactivated" lights on. Is there any point of doing this process in order to fix my problem?
Has the passenger airbag been deactivated ?
@@screwsnutsandbolts No.... Thats the problem
Could be a loose connection under the passenger seat. Is the fault light intermittent or constantly on ?
@@screwsnutsandbolts it is constantly..
Blessed u
Thanks !
👍👍👍
Thanks !