Great tutorial! Here's a tip: If you don't see lines, try zooming in/out. I found my EZCad glitches and some lines disappear which was very confusing because I thought I didn't set parameters right, but it was just a visual glitch :) BTW is there any way to do ruler in Inches?
I made 80 mm ruler and it comes out as about 70 mm when measured. It's not my laser either, as I printed it from EZCAD on paper printer. Have you every seen anything like that? Is there some kind of ruler module calibration?
Actually I've had the same issue, the first time I exported my ruler to the work space, the sizing was just a little bit off. I had no explanation as to why it happened, but I think I just remedied it by deleting it from the work space and reloading it in the power ruler area, then I exported it again and the measurements were accurate. A quirk of ezcad I guess. If that doesn't help, the only other things I can think of are to double check focal length and also draw a box and measure it to confirm everything is marking correctly to size.
Great tutorial! Here's a tip: If you don't see lines, try zooming in/out. I found my EZCad glitches and some lines disappear which was very confusing because I thought I didn't set parameters right, but it was just a visual glitch :)
BTW is there any way to do ruler in Inches?
Excellent tutorial - thx
Hi I have problem when I put long text engraving machine the whole text isnt straight can I set up it ?
GRATE I AM VERY HAPPY TO SEE THIS VIDEO.
😍😍😍😍😍😍😍😍😍😍😍😍
Excilent, but how to use rotary text can u plz share video of rotary text mark of ruler
I made 80 mm ruler and it comes out as about 70 mm when measured. It's not my laser either, as I printed it from EZCAD on paper printer. Have you every seen anything like that? Is there some kind of ruler module calibration?
Actually I've had the same issue, the first time I exported my ruler to the work space, the sizing was just a little bit off. I had no explanation as to why it happened, but I think I just remedied it by deleting it from the work space and reloading it in the power ruler area, then I exported it again and the measurements were accurate. A quirk of ezcad I guess.
If that doesn't help, the only other things I can think of are to double check focal length and also draw a box and measure it to confirm everything is marking correctly to size.