How To Read & Clear Codes Check Engine Lights 1988-1995 Mercedes Benz Onboard Button OBD1

How To Read & Clear Codes Check Engine Lights 1988-1995 Mercedes Benz with the Onboard Button.
Fault Code Table Chart:
www.mbslk.de/f...
Like, Comment, Subscribe!

[@alecmoen6340]

Thanks for the information! Looking forward to future videos.

[@joeynadolski7042]

Good video. Thank you

[@Artsalloverone]

Thanx for the much needed information and the code reader codes download

[@partsandprojects]

Glad to help!

[@Badman-fc9vf]

Mercedes Benz is an AWESOME VEHICLE.

[@partsandprojects]

Couldn't agree more!

[@alexzamora8491]

To the right of the diagnostic port what is that part called? It’s that grey thing next to the #8 on the right

[@rioraton]

So, mine is a 92 500sl and I do not have that button that you pushed... I had to buy a blink code reader? What year is the car you showed?

[@partsandprojects]

Mine is a 91

[@rioraton]

I will have to recheck mine and see if there is a button on mine@@partsandprojects

[@RonaldLewis-e5s]

My 1995 SL500 (R129) does not have a analog box on your video. How do I clear the CEL on my SL 500

[@sasharash8621]

Thank you for sharing. What about 1993 MB 300D 2.5 L..model _ I see the diagnostic port under hood, but don't see any buttons there.

[@edoardoolini6586]

om, i love you tnx for this video

[@partsandprojects]

Glad we could help!

[@radhaalghurab9753]

Mine is a 95 i dont have this is it located in a different place ?

[@Ihmeine]

Can i read them while its running? I get abs light but only after driving a couple meters and then in the next start it doesnt show it till i drive?

[@partsandprojects]

Unfortunately this is only for engine codes not abs codes

[@berniedmj1]

It’s clearing for me (no red light blinking), but my check engine light is still on.
The only issue I had was my O2 sensor (which I changed out [5 lights]).
I held it for 3 seconds & I get no lights whatsoever.
It should give me at least 1 red light, but it didn’t.
After 3 seconds, I’ve held it for 8-10 seconds (to clear it).
Go back in the car to start it & the check engine light is still on.
So I don’t know what to do next. Help?
Thanks!

[@berniedmj1]

Never mind!
The check engine light is off.
I went back under the car & just made the wires are straight instead of being twisted & what not.
And then I disconnected & reconnected the wire.
After that the check engine light didn’t stay on.
Thank you for your video!