Condensation using Species Mass Transfer Model Ansys Fluent

This video describes about the condensation of water vapor air mixture to water vapor using species mass transfer mechanism
File:
drive.google.c...

[@umairatulafiqah6534]

thank you so muchh! subscribed

[@charlesagbaje200]

Great work . Thanks

[@alihameed9803]

Can I have this file? Please, help me

[@anshulsuri5619]

A great work

[@livewireflyer3590]

Sir in the image of volume fraction, there is condensation happening on the walls even though the water vapor from diffuser never reached to the walls. Is that valid?

[@chavhan6639]

sir, the minimum static temperature is you shown is 273K, is there any freezing in the system?

[@AbdulrahmanElmen]

Sir why not use VOF rather than mixture?

[@umairatulafiqah6534]

is it possible if you do a evaporation simulation like in porous walls?

[@shavantechnology3472]

Sure

[@weili9556]

Thank you so much for the video. It is super helpful. However, in my case, the inlet pressure is 40 Pa, I set the other settings similar to yours. But the continuity curve goes up crazily. And error: floating point exception pops out. Could you please help?

[@weili9556]

Oh I reduce the time step and it works. Cheers

[@chavhan6639]

I'm also fashing the same issue...... anyone helps us?

[@rabipathak6233]

Sir, Can you give me your email address. I had a doubt ,can you clear it.సోదరుడు, ట్యుటోరియల్ కోసం చాలా ధన్యవాదాలు, దయచేసి నా సమస్యకు నాకు సహాయం చెయ్యండి.

[@shavantechnology3472]

[e-mail]

[@rabipathak6233]

@@shavantechnology3472 Please check my mail .