Видео

At a glance, this is the most informative look at the LS exhaust options. Nicely done!👍

Is that alcohol that you used good for prepping because that’s a lot cheaper than the wax and grease remover

So do you have a stock cam or what cam are you using? What is the total cost of LSA upgrade?

Fire 🔥🚒🔥🚒

Hi so I recently installed a solid isolator on my CTs v and instantly could hear ticking did I put it in backwards or is this common

At home 😂

Stuff a rag in the holes when you put those bolts in. If it drops it wont go into engine

Wait, you have already sold this car????

How much did you spend in total and have you ordered the correct 10mm spacers to see how much more it will bring the tire in?

Yellowman fathead nice. Gotta do this now 🤬, can I just put the tube end with the broken connector/nipple still in it, and JB weld it to the little nub that's barely sticking out?

I cant find the brake booster on my tesla

You in tenneseee? My car next

Can this contribute to reduced power mode code p228a & p228b/c pending?

is this for the ls430?

Bt what size compressor do you have? That’s my million dollar question! Plz help

Looks horrible

Attempting to do the same on my G8 GT but bolts from the original caliper bracket are just spinning inside the new zl1 caliper and not tightening

Was that mocha frost Pearl you used?

Nice work. I have a 91 K1500 and I'm wondering how much of this stuff I'm going to have to do.

How you get the ac to work is it controlled with ls computer or the obs

Did you notice any extra vibrations or powersteering noises from the Cunningham steering shaft since it uses u joints?

The smoke is actually the oil in the sea foam getting burned off.

Can you use factory computer, or have to use aftermarket like a Holley?

Did you use the stock throttlebody from the caprice?

You have the link for the hat? I can’t find it

Was the first spot the pcv valve?

Yes please

yeah what happens to the shaving that go inside? don't they end up in the engine?

Careful doing this. This is how I learned my exhaust manifold had a leak

Did you end up getting dyno numbers or know how mucb boost youre running?

I guess you don’t put it in fuel tank..

Which model of the engine?

Do they make a stock size grip tech pulley? I only got the 2.45 I ordered already on the blower when I bought it and they didn’t include the stock pulley. I’m wanting to run the stock pulley until I can have my heads and blower ported

If body bushings are worn it wears the rag joint out faster because of the angle. You have to check the pivot farther up with the boot that holds grease. I need to do body bushings at 470,000 on the body they are due. I went to a factory fast ratio box and went back to factory standard box. It felt to fast for highways speeds that law enforcement does approve. It took several steering boxes from chain parts tore to get a good one, replaced power steering pump also. And I have adjusted the adjustment screw. Replacing the control arms and steering linkage with moog components gets expensive. But worth it.

I believe that gold stripe on the "adjustment" nut is there to establish where RED HEAD placed it. Moving it voids the warranty. Also, wasn't the purpose of the rag joint to dampen some of the vibration to the steering column from bumps? Did you notice any change in this regard in your hands on the steering wheel?

The realest video I watched about these eraser wheels

What did you do with the coolant hose that went to the oil cooler?

Which model Race Ramp are you using?

What's the torque lb on the gearbox x3 bolts ?

😮😮😮😮nice

Would you know if the lsa supercharger kit for the 2015 Camaro ss is a complete kit? Like will I need to purchase any adapter parts or anything at all for it to be a complete install? I’m kinda confused, because I’ve heard talks of needing a conversion kit as well as the supercharger

Transmission fluid is better on injectors.

I use archoil and she stopped sticking on start and it revs up easy not so slow either, knocked 1.5 seconds off 0-60

Does it actually come with a pin kit for the crank ?

2 stroke oil is the best injector lubricant. Yes ATF is a cleaner but 2 stroke oil is designed to lubricate a crankshaft spinning at 6,000 rpm. It does great with injectors.

No doubt Seafoam works. I do wonder though what happens to the Catalytic converter after doing this.

Did you sand the truck?

Damn things will run on straight ATF

Why do people think diesels sound good? They sound like an annoying rod knocking engine and people are stupid enough to make them "roll coal" when the actual goal should be no smoke, because that means you're getting the most power and efficiency you can

They love atf too.