Видео

Great to hear!

We recommend these two products. One is NA35. ( buydecorativefilm.com/collections/heat-control-films/products/bdf-na35-window-film-sun-control-and-heat-rejection-n35-black-medium ) The other one is NC35. ( buydecorativefilm.com/collections/heat-control-films/products/bdf-nc35-window-film-premium-high-performance-heat-control-nichrome-35-medium ) But these two has mild daytime privacy. Please refer the specification sheets for both films at the bottom part of the above pages. We hope this info helps you to find the right film.

@@BDFBuyDecorativeFilm Ok looking into it, I cannot use the NC35 because I have dual pane windows. I am interested in the NA35 and the S35. I can't really tell the privacy capabilities from the stock photos. Is there a way I can pay to get small samples from these two (NA35 and the S35)? Or do I just buy both and return the one I don't like? Thank you again.

S35 is mirror finish and the NA35 is a black finish?

@@Falcon408 We can send small samples upon request. Please send a request to cs@buydecorativefilm.com.

@@Falcon408 Yes, they are.

Awesome, thank you!

Please try this link. ruclips.net/video/c8aSQzCok84/видео.html

Please try this link. ruclips.net/video/c8aSQzCok84/видео.html

Glad you liked it!

Great to hear!

You're very welcome!

Thank you for comments.

Glad to hear that!

Hi! Please contact our customer service. cs@buydecorativefilm.com or 1-800-291-5458. We will check your order details first, and then confirm you which side shall be installed on window. For your reference, adhesive side has to be applied on the window after removing the backing liner.

You are welcome.

Some window films are not suitable for dual pane/insulated windows because of possible stress on the window caused by the high heat absorption rate. Heat does not necessarily break the glass, but it can add stress on the glass. BDF 8Mil Security films(S8MC & S8MB series) can be applied on the inside of double pane windows. Our security film is made for the application on the interior side of window, not for exterior. We hope this helps you.

If the release liner is taken off and adhesive side is installed on the window properly, it will not be dropped off.

With any window film, it is important that the soapy solution used during installation should be properly squeezed out with the squeegee once the film is up on the window. If there is soapy water left over between the film and the window, the moisture can interfere with the adhesive and cause bubbles to form soon afterwards, even if it was not apparent on the day of installation. Bubbles can happen with any film, but they can pose a problem particularly for security films, due to the increased thickness that makes it harder to squeeze out the water. This necessitates applying more pressure with the squeegee than for thinner films. A suggested tip is to first spray some soapy water on top of the film after it is on the window, before you apply the squeegee. This can help the squeegee glide over the film more easily. Note that the felt or tape side of the squeegee would ordinarily be used for this process; the other plastic or rubber side can be used when precision is needed, such as corners. Bubbles should be prevented in advance. Unlike cloudiness or streaks, bubbles would likely not disappear once they form, unless they are small enough (those about 1/8 inch or less in diameter can disappear as the film dries). If there are bubbles in a few specific spots, you can use a needle to poke the bubbles and let the air out from the gap, helping that spot stick. However, for security films, this can weaken these spots.

Please click the below link. We hope this video helps you to find an answer about your question. ruclips.net/video/KX5NcyT_lFM/видео.htmlsi=qL7aOMZQYi7r1X8s

@@BDFBuyDecorativeFilm thanks!

Please click the below link for your question. buydecorativefilm.com/blogs/window-film-tips-and-information/how-thick-is-window-film-and-what-is-a-mil

Sorry to hear. Please refer the below link about Security Film Installation. buydecorativefilm.com/blogs/window-film-tips-and-information/how-thick-is-window-film-and-what-is-a-mil We hope this helps you to solve.

Great to hear!

Please use thicker one to install on the window. Thinner one is release liner which protect adhesive side of thicker film.

Sorry to hear. Please contact us via email (cs@buydecorativefilm.com) for further assistance.

Yes, thank you. I will for sure contact you guys.@@BDFBuyDecorativeFilm

Great to hear!

Same here🤣

You're welcome!

Sorry to hear. Another option for easier installation is pre-cut. Before installation, cut the film as the size of window first. And this make you to finish the installation without the trim process. Hopefully, this helps you.

Great to hear.

Sorry to hear. Please refer our FAQ link as below for the further info. buydecorativefilm.com/pages/faq

Great to hear.